408-8644
Rev C
4. Discard the housing.
5. Refer to instruction sheet 408-8647 to remove the chicklets from the pc board.
4. MAINTENANCE AND INSPECTION
4.1. Daily Maintenance
It is recommended that each operator be made aware of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants with a clean, soft brush, or lint-free cloth. DO NOT
use objects that could damage the tool.
2. When the tool is not in use, store it in a clean, dry area.
4.2. Periodic Inspection
It is recommended that the tool be inspected using Figure 3 immediately upon its arrival to ensure that it has
not been damaged during shipment.
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the tool or be supplied to personnel responsible for the tool. The inspection frequency
should be based on the amount of use, working conditions, operator training and skill, and established
company standards.
Figure 3
5. REPLACEMENT AND REPAIR
Order removal tools through your representative, or call 1-800-526-5142, or send a facsimile of your purchase
order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, call 1-800-526-5136.
6. REVISION SUMMARY
Revisions to this instruction sheet include:
Updated document to corporate requirements
Added new tools 1583224-5 and -6 to tables in Figures 1 and 3
TOOL
0.864 ±0.025
[.034 ±.001]
