DS4250P+

Pin Description
DS4125–DS4776
DS4-XO Series Crystal Oscillators
4 _______________________________________________________________________________________
SINGLE-SIDEBAND PHASE NOISE AT f
O
= f
NOM
(dBc/Hz)
f
M
=
77.76MHz 125.00MHz 155.52MHz 156.25MHz 160.00MHz 311.04MHz 312.5MHz 622.08MHz
10Hz -60 -70 -70 -70 -70 -65 -65 -60
100Hz -95 -100 -100 -100 -100 -95 -95 -90
1kHz -122 -120 -120 -120 -120 -113 -113 -107
10kHz -126 -120 -120 -120 -120 -113 -113 -107
100kHz -131 -125 -125 -125 -125 -118 -118 -113
1MHz -143 -142 -142 -142 -142 -137 -137 -131
10MHz -149 -149 -149 -149 -149 -149 -149 -147
20MHz -153 -153 -153 -153 -153 -153 -153 -150
PIN NAME FUNCTION
1 OE Active-High Output Enable. Has an internal pullup 100k resistor.
2, 7–10 N.C. No Connection. Must be floated.
3 GND Ground
4 OUTP Positive Output for LVPECL or LVDS
5 OUTN Negative Output for LVPECL or LVDS
6 V
CC
Supply Voltage
EP Exposed Paddle. Do not connect this pad or place exposed metal under the pad.
SINGLE-SIDEBAND PHASE NOISE AT f
O
= f
NOM
Typical Operating Characteristics
(V
CC
= +3.3V, T
A
= +25°C, unless otherwise noted.)
FREQUENCY vs. TEMPERATURE
DS4125/776 toc01
TEMPERATURE (°C)
f
OUT
DEVIATION (ppm)
806020 400-20
-18
-15
-13
-10
-8
-5
-3
0
3
5
8
10
13
15
-20
-40
OPERATING CURRENT (DS4155)
vs. OPERATING VOLTAGE
DS4125/776 toc02
V
CC
(V)
I
CC
(mA)
3.4353.3853.3353.2853.2353.185
48
50
53
55
45
3.135
+85°C
0°C
-40°C
+70°C
+40°C
+25°C
DS4125–DS4776
DS4-XO Series Crystal Oscillators
_______________________________________________________________________________________ 5
Detailed Description
The devices consist of a fundamental-mode, AT-cut
crystal and a synthesizer IC that can synthesize any
one of these frequencies: 77.76MHz, 125MHz,
150MHz, 155.52MHz, 156.25MHz, 160MHz, 250MHz,
300MHz, 311.04MHz, 312.5MHz, and 622.08MHz.
All devices support two types of differential output dri-
vers: LVDS and LVPECL. When the OE signal is low,
LVPECL outputs go to the PECL_BIAS level of
V
CC
- 2.0V, while the LVDS outputs are a logical one.
See Figures 2 and 3 for an LVDS and LVPECL output
timing diagram.
Additional Information
For more available frequencies, refer to the DS4106
data sheet at www.maxim-ic.com/DS4106.
X1
X2
TRI-
STATE
PHASE
DET
FILTER
LC-VCO
/n
OUTSELN
/m
OUTDRV
V
CC
GND
OE
OUTP
OUTN
DS4125–DS4776
Figure 1. Functional Diagram
OE
OUTP
t
P1A
t
PA1
0.7 x V
CC
0.3 x V
CC
OUTN
Figure 2. LVDS Output Timing Diagram When OE Is Enabled
and Disabled
OE
OUTP
PECL_BIAS PECL_BIAS
PECL_BIAS PECL_BIAS
OUTN
0.7 x V
CC
0.3 x V
CC
t
PAZ
t
PZA
Figure 3. LVPECL Output Timing Diagram When OE Is Enabled
and Disabled
DS4125–DS4776
DS4-XO Series Crystal Oscillators
6 _______________________________________________________________________________________
Chip Information
SUBSTRATE CONNECTED TO GROUND
PROCESS: BiPOLAR SiGe
THETA-JA (°C/W)
90
Selector Guide
+
Denotes a lead(Pb)-free/RoHS-compliant package. The lead finish is JESD97 category e4 (Au over Ni) and is compatible with both
lead-based and lead-free soldering processes.
PART
FREQUENCY (NOM)
(MHz)
FREQUENCY
STABILITY (ppm)
OUTPUT TYPE TOP MARK
DS4125D+ 125.00 ±50 LVDS 25D
DS4125P+ 125.00 ±50 LVPECL 25P
DS4150D+ 150.00 ±50 LVDS 50D
DS4150P+ 150.00 ±50 LVPECL 50P
DS4155D+ 155.52 ±50 LVDS 55D
DS4155P+ 155.52 ±50 LVPECL 55P
DS4156D+ 156.25 ±50 LVDS 56D
DS4156P+ 156.25 ±50 LVPECL 56P
DS4160D+ 160.00 ±50 LVDS 60D
DS4160P+ 160.00 ±50 LVPECL 60P
DS4250D+ 250.00 ±50 LVDS T5D
DS4250P+ 250.00 ±50 LVPECL T5P
DS4300D+ 300.00 ±50 LVDS 30D
DS4300P+ 300.00 ±50 LVPECL 30P
DS4311D+ 311.04 ±50 LVDS 31D
DS4311P+ 311.04 ±50 LVPECL 31P
DS4312D+ 312.50 ±50 LVDS 32D
DS4312P+ 312.50 ±50 LVPECL 32P
DS4622D+ 622.08 ±50 LVDS 62D
DS4622P+ 622.08 ±50 LVPECL 62P
DS4776D+ 77.76 ±50 LVDS 76D
DS4776P+ 77.76 ±50 LVPECL 76P
Thermal Information
+
Denotes a lead(Pb)-free/RoHS-compliant package. The lead
finish is JESD97 category e4 (Au over Ni) and is compatible with
both lead-based and lead-free soldering processes.
Ordering Information (continued)
PART TEMP RANGE PIN-PACKAGE
DS4311D+ -40°C to +85°C 10 LCCC
DS4311P+ -40°C to +85°C 10 LCCC
DS4312D+ -40°C to +85°C 10 LCCC
DS4312P+ -40°C to +85°C 10 LCCC
DS4622D+ -40°C to +85°C 10 LCCC
DS4622P+ -40°C to +85°C 10 LCCC
DS4776D+ -40°C to +85°C 10 LCCC
DS4776P+ -40°C to +85°C 10 LCCC

DS4250P+

Mfr. #:
Manufacturer:
Maxim Integrated
Description:
Standard Clock Oscillators DS4-XO Series Clock Oscillato
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union