September 2013 Doc ID 14103 Rev 3 1/32
1
TDA7575B
2 x 75W multifunction dual-bridge power amplifier
with integrated digital diagnostics
Features
■ Multipower bcd technology
■ MOSFET output power stage
■ DMOS power output
■ New high-efficiency (class AB)
■ Single-channel 1driving capability
■ High output power capability 2x28 W/4 @
14.4 V, 1 kHz, 10 % THD
■ Max. output power 2x75 W/2 1x150 W/1
■ Single-channel 1 driving capability
■ 84 W undistorted power
■ Full I
2
C bus driving with 4 address possibilities:
– Standby
–Play/mute
– Gain 12/26 dB
– Full digital diagnostic (AC and DC loads)
■ Possibility to disable the I
2
C bus
■ Differential inputs
■ Full fault protection
■ DC offset detection
■ Two independent short circuit protections
■ Diagnostic on clipping detector with selectable
threshold (2 % / 10 %)
■ Clipping detector as diagnostic pin when I
2
C
bus is disabled
■ Standby/mute pins
■ ESD protection
Description
The TDA7575B is a new MOSFET dual bridge
amplifier specially intended for car radio
applications. Thanks to the DMOS output stage
the TDA7575B has a very low distortion allowing
a clear powerful sound.
Among the features, its superior efficiency
performance coming from the internal exclusive
structure, makes it the most suitable device to
simplify the thermal management in high power
sets.The dissipated output power under average
listening condition is in fact reduced up to 50%
when compared to the level provided by
conventional class AB solutions.
This device is equipped with a full diagnostic array
that communicates the status of each speaker
through the I
2
C bus. The TDA7575B has also the
possibility of driving loads down to 1 paralleling
the outputs into a single channel. It is also
possible to disable the I
2
C and control the
TDA7575B by means of the usual standby and
mute pins.
PowerSO36
Flexiwatt27
(slug up)
Table 1. Device summary
Order code Package Packing
TDA7575B Flexiwatt27 Tube
TDA7575BPD PowerSO36 (slug up) Tube
TDA7575BPDTR PowerSO36 (slug up) Tape and reel
www.st.com