DATA SHEET • SKY65605-21: LOW-NOISE AMPLIFIER
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • sales@skyworksinc.com • www.skyworksinc.com
203118D • Skyworks Proprietary and Confidential information • Products and Product Information are Subject to Change Without Notice • August 19, 2015 3
Table 4. SKY65605-21 Electrical Specifications (Note 1)
(V
CC = 2.85 V, VEN = 1.5 V, f = 1575 MHz, TC= +25 C, Unless Otherwise Noted)
Parameter Symbol Test Condition Min Typical Max Units
Small signal gain |S21| PIN = –30 dBm 17 19 21 dB
1 dB input compression point IP1dB –14.5 dBm
Noise figure NF 0.6 (Note 2) dB
In-band third order input intercept point IIP3
f1 = 1575 MHz, P1 = –30 dBm
f2 = 1574 MHz, P2 = –30 dBm
–5
dBm
Out-of-band third order input intercept point OOB-IIP3
f1 = 1713 MHz, P1 = –20 dBm
f2 = 1851 MHz, P2 = –20 dBm
–2
dBm
Reverse isolation |S12| PIN = –30 dBm 37 dB
Input return loss |S11| PIN = –30 dBm 7.5 dB
Output return loss |S22| PIN = –30 dBm 10 dB
Supply current ICC 3.5 4.5 mA
Shutdown current ILEAK 0.1 1.0 μA
Note 1: Performance is guaranteed only under the conditions listed in this table.
Note 2: 0.1dB has been de-embedded for input connector and trace loss.
Table 5. SKY65605-21 Electrical Specifications (Note 1)
(VCC = 1.8 V, VEN = 1.5 V, f = 1575 MHz, TC= +25 C, Unless Otherwise Noted)
Parameter Symbol Test Condition Min Typical Max Units
Small signal gain |S21| PIN = –30 dBm 17 18.5 20.5 dB
1 dB input compression point IP1dB f = 1575.0 MHz –16 (Note 2) dBm
Noise figure NF 0.65 dB
In-band third order input intercept point IIP3
f1 = 1575 MHz, P1 = –30 dBm
f2 = 1574 MHz, P2 = –30 dBm
–7
dBm
Out-of-band third order input intercept point OOB-IIP3
f1 = 1713 MHz, P1 = –20 dBm
f2 = 1851 MHz, P2 = –20 dBm
–5
dBm
Reverse isolation |S12| PIN = –30 dBm 37 dB
Input return loss |S11| PIN = –30 dBm 7 dB
Output return loss |S22| PIN = –30 dBm 10 dB
Supply current ICC 3.3 4.5 mA
Shutdown current ILEAK 0.1 1.0 μA
Note 1: Performance is guaranteed only under the conditions listed in this table.
Note 2: 0.1dB has been de-embedded for input connector and trace loss.