LifecyclePhase:
Revision : 2
Expired Period: Forever
Release Date:2011-10-18 19:28:01.0
59-14UTD/TR8
Everlight Electronics Co., Ltd. http://www.everlight.com Rev.2 Page: 9 of 10
Device No. : DSE-0005849 Prepared date: 17-Oct-2011 Prepared by: Ashley Kuo
Precautions For Use
1. Over-current-proof
Customer must apply resistors for protection, otherwise slight voltage shift will cause big
current change ( Burn out will happen ).
2. Storage
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package: The LEDs should be kept at 30
℃ or less and 90%RH or less.
2.3 After opening the package: The LED's floor life is 1 year under 30
℃ or less and 60% RH or less.
If unused LEDs remain, it should be stored in moisture proof packages.
2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the
storage time, baking treatment should be performed using the following conditions.
Baking treatment : 60±5℃ for 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile
Pre-heating
150~200°C
60~120sec.
Above 217°C
60~150sec.
260°C M ax.
10sec. M ax.
6°C/sec.M ax.
Above255°C
30sec.M ax.
3°C/sec.M ax.
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
