ADIS16IMU1/PCBZ

One Technology Way · P.O. Box 9106 · Norwood, MA 02062-9106 · Tel: 781.329.4700 · Fax: 781.461.3113 · www.analog.com

Rev 25 Jun 2013 19:50 | Page 1

ADIS16IMU1/PCBZ Breakout Board

Wiki-Guide

OVERVIEW

The ADIS1613x, ADIS1636x, ADIS16375, ADIS16407 and ADIS1648x IMU products all use a 24-pin,

dual-row, 1mm connector for their electrical interface. This mating connector for their interface

supports surface-mount solder attachment but does not support direct attachment with ribbon cables.

For those who are would like to connect to these IMU/gyroscope products to an existing processor

products. Please see the following picture for device mounting hole locations.

Rev 25 Jun 2013 19:50 | Page 2

ADIS16133, ADIS16135, ADIS1636 Mounting

Use the M2x0.4x16mm machine screws (provided in pink bag) for mounting these products to the

ADIS16IMU1/PCBZ and set their torque for 20 inch-ounces. The yellow-highlights in the top-view

picture illustrate the location of the mounting holes for these products.

Rev 25 Jun 2013 19:50 | Page 3

ADIS16360, ADIS16362, ADIS16364, ADIS16365, ADIS16367,

ADIS16400, ADIS16405, ADIS16407 Mounting

ADIS16IMU1/PCBZ and set their torque for 20 inch-ounces. The blue-highlights in the top-view picture

illustrate the location of the mounting holes for these products. Here is an example of the

ADIS16IMU1/PCBZ, with an ADIS16485AMLZ mounted to it.

Make sure that the connector pins are in alignment with J2 on the ADIS16IMU1/PCBZ, before pressing

it into place.

Here is a close-up view, which shows the correct connector alignment.