6
SANKEN ELECTRIC CO., LTD.
BR301-DS, Rev. 1.0
3.3 V, 1 A Non-Isolated Step Down DC/DC Converter Module
BR301
September 11, 2012
Typical Application
VIN VO
V
IN
8 to 30 V
C
IN
220 μF
C
O
Electrolytic 470 μF
or Ceramic 30 μF
1
32
4
GND
NC
Load
BR301
Typical application circuit example
• An input electrolytic capacitor, C
IN
, of approximately 220 F should be connected to the input
side of the BR301. If the input voltage is stable, it is not required.
• An output capacitor, C
O
, either electrolytic of approximately 470 F or ceramic of
approximately 30 F should be connected to the output side of the BR301.
• For C
IN
, a YXF type made by Rubycon for switching power supplies or equivalent is
recommended.
• For C
O
, either a low impedance ZL type made by Rubycon, or three ceramic capacitors
connected in parallel (GRM31CR71E106KA12 made by Murata), for switching power
supplies or equivalent are recommended.
• Depending on PCB layout, output voltage ripple could be amplified. Please check the output
voltage ripple in the actual application.