MPX5050
Sensors
Freescale Semiconductor 3
Pressure
Operating Characteristics
Table 1. Operating Characteristics (V
S
= 5.0 Vdc, T
A
= 25°C unless otherwise noted, P1 > P2. Decoupling circuit shown in
Figure 4 required to meet electrical specifications.)
Characteristic Symbol Min Typ Max Unit
Pressure Range
(1)
1.1.0 kPa (kiloPascal) equals 0.145 psi.
P
OP
0—50kPa
Supply Voltage
(2)
2.Device is ratiometric within this specified excitation range.
V
S
4.75 5.0 5.25 Vdc
Supply Current I
o
— 7.0 10 mAdc
Minimum Pressure Offset
(3)
(0 to 85°C)
@ V
S
= 5.0 Volts
3.Offset (V
off
) is defined as the output voltage at the minimum rated pressure.
V
off
0.088 0.2 0.313 Vdc
Full Scale Output
(4)
(0 to 85°C)
@ V
S
= 5.0 Volts
4.Full Scale Output (V
FSO
) is defined as the output voltage at the maximum or full rated pressure.
V
FSO
4.587 4.7 4.813 Vdc
Full Scale Span
(5)
(0 to 85°C)
@ V
S
= 5.0 Volts
5.Full Scale Span (V
FSS
) is defined as the algebraic difference between the output voltage at full rated pressure and the output voltage at the
minimum rated pressure.
V
FSS
—4.5—Vdc
Accuracy
(6)
(0 to 85°C)
6.Accuracy (error budget) consists of the following:
Linearity: Output deviation from a straight line relationship with pressure over the specified pressure range.
Temperature Hysteresis: Output deviation at any temperature within the operating temperature range, after the temperature is cycled to and
from the minimum or maximum operating temperature points, with zero differential pressure applied.
Pressure Hysteresis: Output deviation at any pressure within the specified range, when this pressure is cycled to and from the minimum or
maximum rated pressure at 25°C.
TcSpan: Output deviation over the temperature range of 0° to 85°C, relative to 25°C.
TcOffset: Output deviation with minimum pressure applied, over the temperature range of 0° to 85°C, relative to 25°C.
Variation from Nominal: The variation from nominal values, for Offset or Full Scale Span, as a percent of V
FSS
at 25°C.
———±2.5 %V
FSS
Sensitivity V/P — 90 — mV/kPa
Response Time
(7)
7.Response Time is defined as the time for the incremental change in the output to go from 10% to 90% of its final value when subjected to a
specified step change in pressure.
t
R
—1.0—ms
Output Source Current at Full Scale Output I
o+
—0.1—mAdc
Warm-Up Time
(8)
8.Warm-up Time is defined as the time required for the product to meet the specified output voltage after the Pressure has been stabilized.
——20—ms
Offset Stability
(9)
9.Offset Stability is the product's output deviation when subjected to 1000 hours of Pulsed Pressure, Temperature Cycling with Bias Test.
——±0.5 — %V
FSS
