ADC1010S_SER 3 © IDT 2012. All rights reserved.
Product data sheet Rev. 03 — 2 July 2012 15 of 37
Integrated Device Technology
ADC1010S series
Single 10-bit ADC; CMOS or LVDS DDR digital outputs
11. Application information
11.1 Device control
The ADC1010S can be controlled via SPI or directly via the I/O pins (Pin control mode).
11.1.1 SPI and Pin control modes
The device enters Pin control mode at power-up, and remains in this mode as long as pin
CS
is held HIGH. In Pin control mode, the SPI pins SDIO, CS and SCLK are used as
static control pins.
SPI control mode is enabled by forcing pin CS
LOW. Once SPI control mode has been
enabled, the device remains in this mode. The transition from Pin control mode to SPI
control mode is illustrated in Figure 15.
When the device enters SPI control mode, the output data standard and data format are
determined by the level on pin SDIO at the instant a transition is triggered by a falling
edge on CS
.
11.1.2 Operating mode selection
The active ADC1010S operating mode (Power-up, Power-down or Sleep) can be selected
via the SPI interface (see Table 20) or by using pins PWD and OE
in Pin control mode, as
described in Table 10.
11.1.3 Selecting the output data standard
The output data standard (CMOS or LVDS DDR) can be selected via the SPI interface
(see Table 23) or by using pin ODS in Pin control mode. LVDS DDR is selected when
ODS is HIGH, otherwise CMOS is selected.
Fig 15. Control mode selection
R/W
SPI control mode
Pin control mode
Data format
offset binary
Data format
two's complement
LVDS DDR
SDIO/ODS
SCLK/DFS
W1 W0 A12
005aaa039
CMOS
CS
Table 10. Operating mode selection via pin PWD and OE
Pin PWD Pin OE Operating mode Output high-Z
LOW LOW Power-up no
LOW HIGH Power-up yes
HIGH LOW Sleep yes
HIGH HIGH Power-down yes
