http://www.tracopower.com Page 2 of 4
Input Specifications
Input current at no load – 12 Vin models ±12 / ±15 Vout models: 50 mA typ.
other output models: 110 mA typ.
– 24 Vin models 5.1 / ±5 Vout models: 70 mA typ.
other output models: 40 mA typ.
– 48 Vin models ±15 Vout model: 20 mA typ.
other output models: 44 mA typ.
Input current at full load – 12 Vin models 3.3 Vout models: 2700 mA typ.
other output models: 3000 mA typ.
– 24 Vin models 3.3 Vout models: 1300 mA typ.
other output models: 1500 mA typ.
– 48 Vin models 3.3 Vout models: 650 mA typ.
other output models: 750 mA typ.
Start-up voltage / 12 V models: 9 VDC / 8 VDC typ.
under voltage shut down 24 V models: 18 VDC / 16 VDC typ.
48 V models: 36 VDC / 32 VDC typ.
Surge voltage (100 ms max.) 12 V models: 25 V max.
24 V models: 50 V max..
48 V models: 100 V max.
Conducted noise (input) EN 55032 class A with input capacitor
12 V models: 10 µF / 25 V 1812 MLCC
24 V models: 4.7 µF / 50 V 1812 MLCC
48 V models: 2.2 µF / 100 V 1812 MLCC
Output Specifications
Voltage set accuracy ±1 %
Output voltage adj. range ±10 % (only for single output models)
Regulation – Input variation Vin min. to Vin max. 0.2 % max.
– Load variation 0 – 100 % single output models: 0.5 % max.
dual output models balanced load: 1.0 % max.
dual output models unbalanced load (25% /100%): 5.0 % max.
Minimum load not required
Temperature coefficient ±0.02 %/K
Ripple and noise (20 MHz Bandwidth) 100 mVpk-pk max.
(150 mVpk-pk for 12/±12/15/±15V models)
Start up time (nominal Vin and constant resistive load) 30 ms typ.
Transient response time (25% load change) 250 µs typ.
Short circuit protection indefinite, automatic recovery
Over load protection 150 % of Iout max. typ.
Over voltage protection 3.3 VDC models: 3.9 V
5.1 VDC models: 6.2 V
12 VDC models: 15 V
15 VDC models: 18 V
Capacitive load (max.) 3.3 Vout models: 20’000 µF
5.1 Vout models: 14 ’4 0 0 µ F
12 Vout models: 3’000 µF
15 Vout models: 2’000 µF
±5 Vout models: 3’000 µF (each output)
±12 Vout models: 2’000 µF (each output)
±15 Vout models: 1’300 µF (each output)
DC/DC Converters
TEN 30 Series, 30 Watt
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.