HAMMOND
MANUFACTURINGTM
ENCLOSURES
TOOL BOX
BUL10249
HANDLE KIT
ASSEMBLY INSTRUCTIONS FOR LATCH KITS
REV. D
PAGE 1 OF 1
C
L
5
2
4
3
1
PART# QTY. DESCRIPTION
1 1 PAD LOCKING HANDLE
2 1 HANDLE HARDWARE (SCREW, WASHERS, NUT AND GASKET)
3 1 CAM
4 1 INTERNAL SPACER
5 1 HEX NUT M10 CTR-LOCK AND FLAT WASHER
PART A
6" HANDLE 1.338" (34mm)
8" HANDLE 1.417" (36mm)
MARK AND DRILL DOOR AT LOCATIONS DISPLAYED IN THE DRILLING DETAIL.
MOUNT GASKET TO HANDLE (PART 1) . SLIP THREADED SHAFT THROUGH .866" (22.5mm) DIA. HOLE IN
DOOR AND HOLD ONTO HANDLE. FASTEN HANDLE TO DOOR USING SCREW, WASHERS AND NUT
SUPPLIED (PART 2). NOTE: HANDLE CAN BE MADE TO OPEN CLOPCKWISE OR COUNTER - CLOCKWISE
BY CHANGING POSITION OF DOG LOCATED UNGER HANDLE ESCUTCHEON.
SLIP SPACER (PART 4) THAT COMES WITH HANDLE OVER SHAFT.
SLIP CAM (PART 3) OVER SHAFT, PINS FACING UP AND LATCH FACING OUT 90 DEGREES TO HANDLE.
TIGHTEN M12 CENTER- LOCK NUT AND FLAT WASHER (PART 5) AS SHOWN.
NOTE: FOR LEFT HAND HANDLE MOUNT HARDWARE OPPOSITE.
THREADED SHAFT
SEE STEP E
GASKET
SEE STEP B
ESCUTCHEON
SEE STEP B
ENCLOSURE DOOR
ASSEMBLY INSTRUCTIONS
A)
B)
C)
D)
E)
Centre
Punch
Drill, use 886
(22.5mm), .334
(8.5mm) Drill Bits
Hammer
10mm and 17mm
Socket Wrench
DRILLING DETAIL TOP VIEW
O 0.886
2.500 A
O 0.334
1 1/16 Open
End Wrench
Tape
Measure
PHK1 8" HANDLE W/PADLOCK
PHKL1 8" HANDLE W/PADLOCK/KEYLOCK
PHKD1 8" HANDLE W/PADLOCK/DEFEATER
MHKL1 6" HANDLE W/PADLOCK/KEYLOCK
MHK1 6" HANDLE W/PADLOCK
MHKD1 6" HANDLE W/PADLOCK/DEFEATER
MHKLSS1 6" SS HANDLEW/PADLOCK/KEYLOCK
MHKSS1 6" SS HANDLE W/PADLOCK
MHKDSS1 6" SS HANDLE W/PADLOCK/DEFEATER
