SPEC NO: DSAE9383 REV NO: V.15A DATE: FEB/14/2017 PAGE: 2 OF 5
APPROVED: Wynec CHECKED: Allen Liu DRAWN: W.Q.Zhong ERP: 1102013559
Selection Guide
Notes:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 of the optical peak value.
2. Luminous intensity/ luminous Flux: +/-15%.
* Luminous intensity value is traceable to CIE127-2007 standards.
Absolute Maximum Ratings at TA=25°C
Electrical / Optical Characteristics at TA=25°C
Notes:
1.Wavelength: +/-1nm.
2.Forward Voltage: +/-0.1V.
3.Wavelength value is traceable to CIE127-2007 standards.
4.Excess driving current and/or operating temperature higher than recommended conditions may result in severe light degradation or
premature failure.
Part No. Emitting Color (Material) Lens Type
Iv (mcd) [2]
@ 10mA
Angle [1]
Min. Typ. 2θ1/2
High Efficiency Red (GaAsP/GaP) Red Diffused
8 15
70°
*4 *8
WP4060VH/2ID
Symbol Parameter Emitting Color Typ. Max. Units Test Conditions
λpeak Peak Wavelength High Efficiency Red 627 nm IF=10mA
λD [1] Dominant Wavelength High Efficiency Red 617 nm IF=10mA
Δλ1/2 Spectral Line Half-width High Efficiency Red 45 nm IF=10mA
C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz
VF [2] Forward Voltage High Efficiency Red 1.9 2.5 V IF=10mA
IR Reverse Current High Efficiency Red 10 uA VR = 5V
Parameter Values Units
Power dissipation 75 mW
DC Forward Current 30 mA
Peak Forward Current [1] 160 mA
Reverse Voltage 5 V
Operating/Storage Temperature -40°C To +85°C
Lead Solder Temperature [2] 260°C For 3 Seconds
Lead Solder Temperature [3] 260°C For 5 Seconds
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
3. 5mm below package base.
4. Relative humidity levels maintained between 40% and 60% in production area are recommended to avoid the build-up of static
electricity – Ref JEDEC/JESD625-A and JEDEC/J-STD-033.
