ELECTRICAL CHARACTERISTICS 2
(T
A = +25°C, Vcont (H) = 1.8 V, Vcont (L) = 0 V, DC cut capacitors = 56 pF, unless otherwise specified)
Parameter Symbol Test Conditions MIN. TYP. MAX. Unit
Insertion Loss 1 LINS1 f = 0.05 to 1.0 GHz
Note 1
−
0.40 0.47
Insertion Loss 2 LINS2 f = 1.0 to 2.0 GHz
−
0.46 0.52
Insertion Loss 3 LINS3 f = 2.0 to 2.5 GHz
−
0.48 0.57
Insertion Loss 4 LINS4 f = 2.5 to 3.0 GHz
−
0.54 0.62
dB
Isolation 1 ISL1 f = 0.05 to 1.0 GHz
Note 1
23 27
−
Isolation 2 ISL2 f = 1.0 to 2.0 GHz 16 19
−
Isolation 3 ISL3 f = 2.0 to 2.5 GHz 14 17
−
Isolation 4 ISL4 f = 2.5 to 3.0 GHz 14 17
−
dB
Input Return Loss RLin f = 0.05 to 3.0 GHz
Note 1
15 20
−
dB
Output Return Loss RLout f = 0.05 to 3.0 GHz
Note 1
15 20
−
dB
Pin (0.1 dB) f = 2.0/2.5 GHz +19.0 +22.0
−
0.1 dB Loss Compression
Input Power
Note 2
f = 0.5 to 3.0 GHz
−
+22.0
−
dBm
1 dB Loss Compression
Input Power
Note 3
Pin (1 dB) f = 0.5 to 3.0 GHz
−
+25.0
−
dBm
Switch Control Current Icont No signal
−
0.2 20
µ
A
Switch Control Speed tSW 50% CTL to 90/10% RF
−
50 500 ns
Notes 1. DC cut capacitors = 1 000 pF at f = 0.05 to 0.5 GHz
2. Pin (0.1 dB) is measured the input power level when the insertion loss increases more 0.1 dB than that of
linear range.
3. P
in (1 dB) is measured the input power level when the insertion loss increases more 1 dB than that of linear
range.
Caution This device is used it is necessary to use DC cut capacitors.
The value of DC cut capacitors should be chosen to accommodate the frequency of operation,
bandwidth, switc
hing speed and the condition with actual board of your system. The range of
recommended DC cut capacitor value is less than 100 pF.
Data Sheet PG10578EJ02V0DS
4
µ
PG2158T5K
Not Recommended
For New Design
