3
dc682af
DEMO MANUAL DC682A
harDware setup
Jumpers
JP1: Select connection for COM pin, either grounded or
externally supplied through the COM turret.
JP2: Select reference, either internal or the onboard
LT1019 reference.
Analog Connections (Turret Posts)
COM: LTC1859 COM pin. Make sure to select EXT on JP1
when supplying an external bias to this post.
CH0–CH7: Analog inputs to LTC1859. Each input is by
-
passed to ground with a 1000pF capacitor.
V
REF
: Reference pin on LTC1859. When JP2 is set to INT,
the LTC1859 uses its internal reference, or an external
reference can be connected to this pin, overdriving the
internal reference. When JP2 is set to LT1019, this turret
should only be used for monitoring the reference voltage.
Grounding and Power Connections
DC682A does not require any external power source when
used with the DC590 USB controller board. However, an
external 5V power source can be connected to the V
CC
and ground turrets if the power supply on DC590 has
been disabled. Refer to the DC590 demo manual for more
information.