2313669 Datasheet 2313669 | P4-P6

PSI-MODEM-SHDSL/SERIAL

104460_en_04 PHOENIX CONTACT 4/9

4 Technical data

Power supply

Supply voltage 18 V DC ... 30 V DC via plug-in COMBICON screw terminal

block

24 V DC ±5 % (alternative or redundant, via DIN rail connec-

tor and system power supply unit)

5 V DC (configuration only, via mini-USB type B)

Nominal current consumption < 180 mA at 24 V

LED indicator VCC (green LED)

– Steady light: operation

– Flashing at 1 Hz: supply via USB (for configuration)

Switching outputs 2 x V

Nom

/ 150 mA (the digital outputs cannot be used for

power supply via the DIN rail connector), short-circuit-proof

SHDSL interface

Connection method 2 x 2-pos. COMBICON plug-in screw terminal block

Type SHDSL interface according to ITU-T G.991.2.bis

Transmission rate

4-wire operation

2-wire operation

64 kbps ... 30 Mbps (manual setting of the data rate)

384 kbps ... 11.39 Mbps (automatic detection of the data rate)

32 kbps ... 15.3 Mbps (manual setting of the data rate)

192 kbps ... 5.696 Mbps (automatic detection of the data rate)

Transmission length Over 20 km possible at lower data rates and with good cable

quality

Connection data (conductor cross section) 0.2 mm² ... 2.5 mm² (24 - 14 AWG)

Status and diagnostics indicators 2 x LINK, 2 x STAT (DSL data traffic port A and port B)

DIAG (yellow LED), diagnostic messages

ERR (red LED), errors

TERM (yellow LED), only relevant for RS-485

RS232 (yellow LED)

RS-232 interface

Connection method D-SUB 9-pos. plug

Type RS-232 interface, according to ITU-T V.28, EIA/TIA-232,

DIN 66259-1

Transmission rate Can be freely parameterized from 92 bps ... 230.4 kbps

Transmission length Maximum 15 m

Supported protocols Software handshake (Xon/Xoff), hardware handshake

(RTS/CTS), 3964R-compatible, Modbus RTU/ASCII,

transparent protocol - other protocols supported

Data format/coding Serial asynchronous UART/NRZ, 7/8 data bits, 1/2 stop bits,

1 parity bit (even, odd, mark, space, none),

9/10/11-bit character length

PSI-MODEM-SHDSL/SERIAL

104460_en_04 PHOENIX CONTACT 5/9

RS-422 interface

Connection method Plug-in/screw connection via COMBICON plug

Type RS-422 interface, according to ITU-T V.11, EIA/TIA-422,

DIN 66348-1

Transmission rate Can be freely parameterized from 92 bps ... 2 Mbps

Transmission length Maximum 1200 m

Supported protocols Modbus RTU/ASCII and others, transparent protocol

Data format/coding Serial asynchronous UART/NRZ, 7/8 data bits, 1/2 stop bits,

1 parity bit (even, odd, mark, space, none),

9/10/11-bit character length

RS-485 interface

Connection method Plug-in/screw connection via COMBICON plug

Type RS-485 interface, according to EIA/TIA-485, DIN 66259-

4/RS-485 2-wire

Transmission rate Can be freely parameterized from 92 bps ... 2 Mbps

Transmission length Maximum 1200 m

Supported protocols Modbus RTU/ASCII and others, transparent protocol

Data format/coding Serial asynchronous UART/NRZ, 7/8 data bits, 1/2 stop bits,

1 parity bit (even, odd, mark, space, none),

9/10/11-bit character length

USB interface (configuration/diagnostics)

Connection method Mini-USB type B, 5-pos.

Type USB 2.0

Transmission length Maximum 5 m, only for configuration and diagnostics

General data

Ambient temperature range

Operation (no other modules supplied via the device):

– Freestanding (40 mm spacing)

– Connected in series (low power dissipation of mod-

ules connected in series)

– Connected in series (without restrictions)

-20°C ... +60°C

-20°C ... +55°C

-20 °C ... +50 °C

Operation (other modules supplied via the device (max.

1.5 A))

-20 °C ... +45 °C

Storage/transport -40 °C ... +85 °C

Housing ME 35 with 5-pos. bus contact and ground contact

Material PA 6.6-FR, V0, green

Dimensions (H x W x D) 99 x 35 x 114.5 mm

Weight 205 g

Functional earth ground Housing contact to DIN rail

Degree of protection IP20

Electrical isolation DIN EN 50178

(Supply // RS-485, RS-422 // DSL port A // DSL port B // FE)

PSI-MODEM-SHDSL/SERIAL

104460_en_04 PHOENIX CONTACT 6/9

SN 29500 standard, temperature 25°C,

operating cycle 21% (5 days a week, 8 hours a day)

693 years

SN 29500 standard, temperature 40°C,

operating cycle 34.25% (5 days a week, 12 hours a day)

301 years

SN 29500 standard, temperature 40°C,

operating cycle 100% (7 days a week, 24 hours a day)

121 years

Test voltage 1.5 kV

rms

, 50 Hz, 1 min.

Vibration resistance According to IEC 60068-2-6: 5 g, 150 Hz

Shock resistance 15g in each space direction, according to IEC 60068-2-27

Noise emission EN 55011

Noise immunity EN 61000-6-2

Electromagnetic compatibility Conformity with EMC Directive 2014/30/EU

UL, USA/Canada UL 508 listed

Manufacturer's declaration EN 50121-4 (Railway applications - Electromagnetic com-

patibility, Part 4: Emission and Immunity of the Signaling and

Telecommunications Apparatus)

Exceptions include installations within the 3 m area and

safety-related devices. For these devices, there are further

requirements according to EN 50121-4 Table 1, Note 1.

Section 1, Paragraph 3 of EN 50121-4 applies.

Phoenix Contact QUINT power supply units are to be used

directly on the device.

ATEX X II 3 G Ex nA nC IIC T4 Gc X

General data [...]

P1-P3 P4-P6 P7-P9

2313669

Mfr. #:

Buy 2313669

Manufacturer:

Phoenix Contact

Description:

Modems PSI-MODEM- SHDSL/SERIAL

Lifecycle:

New from this manufacturer.

Delivery:

DHL FedEx Ups TNT EMS

Payment:

T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet

2313669