STANDARD
SIZE
A
5962-93131
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
C
SHEET
3
DSCC FORM 2234
APR 97
1.3 Absolute maximum ratings. 1/
Supply voltage (±V
S
) ............................................................. ±18 V dc
Common mode input voltage (V
CM
) ...................................... ±V
S
Differential input voltage (V
ID
) ............................................... ±6 V dc
Power dissipation (P
D
): 2/
Case P ................................................................................ 1.3 W
Case 2 ................................................................................ 2.1 W
Lead temperature range (soldering 60 seconds) ................... +300°C
Storage temperature range .................................................... -65°C to +150°C
Thermal resistance, junction-to-case (θ
JC
) ............................ See MIL-STD-1835
Thermal resistance, junction-to-ambient (θ
JA
):
Case P ................................................................................ 110°C/W
Case 2 ................................................................................ 70°C/W
1.4 Recommended operating conditions.
Power supply voltage range (±V
S
) ......................................... ±4.5 V to ±18 V
Ambient operating temperature range (T
A
) ............................ -55°C to +125°C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATION
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883 - Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://quicksearch.dla.mil
or from the Standardization Document Order
Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
________
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ Maximum power dissipation is specified so that T
J
does not exceed +175°C at an ambient temperature of +25°C.
Derate above T
A
= +25°C for case P at 9 mW/°C and case 2 at 14 mW/°C.
