Typical Operating Characteristics
(V
RS+
= +12V, V
CC
= +12V, R
LOAD
= 1MΩ, V
RESET
= 0V, V
SENSE
= 100mV, V
PULL-UP
= +5V, R
PULL-UP
= 10kΩ, T
A
= +25°C, unless
otherwise noted.)
MAX4373/MAX4374/MAX4375
Low-Cost, Micropower, High-Side Current-Sense
Amplifier + Comparator + Reference ICs
4 _______________________________________________________________________________________
Note 1: All devices are 100% production tested at T
A
= +25°C. All temperature limits are guaranteed by design.
Note 2: Guaranteed by PSR test.
Note 3: Guaranteed by OUT Voltage Error test.
Note 4: Guaranteed by Gain Accuracy test. Output voltage is internally clamped not to exceed 12V.
Note 5: Total OUT Voltage Error and Full-Scale Accuracy are the sum of gain and offset voltage errors.
Note 6: Measured at I
OUT
= -500µA (R
LOAD
= 4kΩ for gain of +20V/V, R
LOAD
= 10kΩ for gain of +50V/V, R
LOAD
= 20kΩ for gain of
+100V/V).
Note 7: +6.25mV = 1/16 of +100mV full-scale voltage.
Note 8: The device will not experience phase reversal when overdriven.
Note 9: All comparator tests are done with V
RS+
= +12V.
Note 10: V
PULL-UP
is defined as an externally applied voltage through a resistor to pull up the comparator output.
Note 11: V
OS
is extrapolated from the gain accuracy test.
ELECTRICAL CHARACTERISTICS (continued)
(V
CC
= +2.7V to +28V, V
RS+
= 0 to +28V, V
SENSE
= 0V, V
RESET
= 0V, R
LOAD
= 1MΩ, T
A
= T
MIN
to T
MAX
, unless otherwise noted.
Typical values are at T
A
= +25°C.) (Note 1)
V
CC
= 28V, V
PULL-UP
= 5V (Note 10)
CONDITIONS
µA1Output High Leakage Current
UNITSMIN TYP MAXSYMBOLPARAMETER
V2.0V
IH
RESET Input High Voltage
V0.8V
IL
RESET Input Low Voltage
V
IL
= 0, V
IH
= 5.5V, V
CC
= 28V µA-0.5 0.5I
IL
, I
IH
Logic Input Current
µs3t
RPD
RESET Propagation Delay
µs1.5t
RPW
Minimum RESET Pulse Width
