Ethernet RJ45 Male Plug Terminal Block
PRODUCT ID: 2913
Description
If you need to connect an RJ45 cable (a.k.a Ethernet) to a board that with an Ethernet Jack - this adapter
will come in very handy! No soldering required. Just use a slim screwdriver to open up the terminal
blocks, slide in your stranded or solid-core wire and re-tighten. Note that these aren't recommended for
actual Ethernet traffic, especially long term...but for basic power/data distribution, RJ45's are great!
This is the Ethernet (RJ45) Male Plug Terminal Block. There is a standard RJ45 Ethernet plug on one
end, and a screw terminal block on the other.
We also have a (matching) Ethernet Female Jack Terminal Block.
TechnicalDetails
o Length (end to end): 53.9mm / 2.12"
o Weight: 17.7g
EngineeredinNYCAdafruit®https://www.adafruit.com/product/29135‐17‐17
