B7A Link Overview
B7A Link Overview
4
3
MIXED I/O LINK MODULES
Screw Terminal Model (with 16 Input and 16 Output Points)
Appearance I/O configuration I/O delay (typical) Error processing
(See Note 1)
Part number Stan-
dards
NPN compatible/
NPN open collector 100 mA/point
16 input/16 output points
Normal speed 19.2 ms
High speed 3 ms
(switch selectable)
HOLD/
LOAD OFF (switch
setting)
B7AM-6BS
-- -- --
Screw Terminal Models (with 8 Input and 8 Output Points)
Appearance I/O configuration I/O delay (typical) Error processing
(See Note 1)
Part number Stan-
dards
NPN compatible/
Normal speed 19.2 ms HOLD
B7AM-8B11
-- -- --
NPN open collector 100 mA/point
p
p
p
LOAD OFF
B7AM-8B31
npu
ou
pu
po
n
s
High speed 3 ms HOLD
B7AM-8B16
LOAD OFF
B7AM-8B36
PNP compatible/
PNP open collector 100 mA/point
8 input/8 output points
Normal speed 19.2 ms LOAD OFF
B7AM-8F31
3
INPUT LINK CONNECTOR MODULE (M12 CONNECTORS)
10-point Terminal Models
Appearance Description I/O
configuration
I/O delay
(typical)
Enclosure
rating
Part number Stan-
dards
B7A 10-point sealed
input module
NPN compatible 19.2 ms
IP67
B7AC-T10A1
UL
CSA
CE
(See
DeviceNet interface
module connects up to
3 B7AC modules
IP66
DRT1-B7AC
ote
3
10-POINT TERMINALS
Transistor I/O Link Modules
Appearance I/O classification I/O configuration Internal I/O
common
Error
processing
(See Note 1)
Part number Stan-
dards
Input,
p
NPN compatible (No
-- common -- -- --
B7A-T10S1
UL
10 po
nts
(See Note 2)
two-w
re sensor can
be connected.)
+/-- common -- -- --
B7A-T10S3
CE
Output,
10 points
NPN open collector
100 mA/point
+ common HOLD
B7A-R10SC01
(See
Note 3)
Printed Circuit Board Models
Appearance I/O classification I/O configuration Error processing
(See Note 1)
Part number Stan-
dards
Input, 10 points TTL input -- -- --
B7A-T10M2
UL
CSA
Output, 10 points NPN open collector 50 mA/point HOLD
B7A-R10MC
E
(See
Note 3)
Note: 1. HOLD: The previous output condition will be on hold when an error results.
LOAD OFF: All outputs will be OFF when an error results.
2. The 10-point B7A-T10S1 and 10-point B7A-T10S3 are different from each other in terminal configuration.
3. Information on EC Directives
Individual OMRON products that comply with EC Directives conform to the common emission standards of EMC Directives.
However, the emission characteristics of these products installed on customers’ equipment may vary depending on the configu-
ration, wiring, layout, and other conditions of the control panel used. For this reason, customers are requested to check whether
the emission characteristics of the entire machine or equipment comply with the EMC Directives.