TOTAL HARMONIC DISTORTION
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
7 units (circuit breaker of type B) / 12 units (circuit breaker of type C) at 347VAC
SPECIFICATION
MODEL
DC VOLTAGE
RATED CURRENT
RATED POWER
Note.5
OUTPUT
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME
Note.6
VOLTAGE RANGE Note.5
FREQUENCY RANGE
POWER FACTOR
(Typ.)
EFFICIENCY (Typ.)
AC CURRENT(Typ.)
INPUT
INRUSH CURRENT
(Typ.)
LEAKAGE CURRENT
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVER VOLTAGE
OVER TEMPERATURE
500ms, 100ms / 347VAC 700ms, 100ms / 230VAC,277VAC
200 ~ 400VAC 282 ~ 565VDC
47 ~ 63Hz
COLD START 40A(twidth=550 s measured at 50% Ipeak) at 347VACμ;Per NEMA 410
<0.75mA / 347VAC
20 ~ 95% RH non-condensing
-40 ~ +90 , 10 ~ 95% RH℃
±℃ ℃0.03%/ (0 ~ 50 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
162.5*43*32mm (L*W*H)
0.45Kg; 32pcs/15.4Kg/0.93CUFT
Shut down o/p voltage, auto-recovery or re-power on to recovery
RIPPLE & NOISE
(max.) Note.3
VOLTAGE TOLERANCE
Note.4
ENVIRONMENT
SAFETY &
EMC
PROTECTION
Shut down o/p voltage, auto-recovery or re-power on to recovery
SHORT CIRCUIT
Hiccup mode, recovers automatically after fault condition is removed.
0.4A / 230VAC,277VAC 0.32A / 347VAC
ISOLATION RESISTANCE
SAFETY STANDARDS
WITHSTAND VOLTAGE
I/P-O/P:3.0KVAC
I/P-O/P:100M Ohms / 500VDC / 25 / 70% RH℃
Compliance to FCC part 15 class B ,EAC TP TC 020(@load 60%)≧
EMC EMISSION
UL8750 , CSA C22.2 No. 250.0-08, IP67 approved(type”HL”) EAC TP TC 004,
File Name:LPFH-60-SPEC 2018-01-11
LPFH-60 series
EMC IMMUNITY
Compliance to IEC61000-4-2,4,5; ,EAC TP TC 020light industry level (surge immunity : Line-Line:2KV)
OVER CURRENT
95 ~ 108%
Hiccup mode, recovers automatically after fault condition is removed
12V
7.2 ~12V
15V
9 ~ 15V
24V
14.4 ~ 24V
36V
21.6 ~ 36V
48V
28.8 ~ 48V
5A 4A
2.5A
1.67A
1.25A
60W 60W
60W
60.12W
60W
150mVp-p 150mVp-p
150mVp-p
250mVp-p
250mVp-p
±4.0% ±4.0%
±4.0%
±4.0%
±4.0%
±0.5% ±0.5%
±0.5%
±0.5%
±0.5%
±2.0% ±1.5%
±0.5%
±0.5%
±0.5%
86%
87%
89%
90%
90%
54V
32.4 ~ 54V
1.12A
60.48W
350mVp-p
±4.0%
±0.5%
±0.5%
42V
25.2 ~ 42V
1.43A
60.06W
250mVp-p
±4.0%
±0.5%
±0.5%
90%
90%
15 ~ 17V 17.5 ~ 21V
28 ~ 35V 41 ~ 49V
54 ~ 63V
46 ~ 54V
59 ~ 66V
LPFH-60-12 LPFH-60-15
LPFH-60-24 LPFH-60-36
LPFH-60-42
LPFH-60-48
LPFH-60-54
HOLD UP TIME (Typ.)
10ms/230VAC,277VAC 10ms/347VAC
CONSTANT CURRENT REGION Note.2
60W Constant Voltage + Constant Current LED Driver
(Please refer to "STATIC CHARACTERISTIC" section)
PF 0.95/230VAC, 277VAC, PF 0.92/347VAC@full load≧≧
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
THD< 20%(@load 60%/230VC,277VAC; @load 75%/347VAC)≧≧
(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)
MAX. CASE TEMP.
Tcase=+90℃
Tcase=-40 ~ +90 (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)℃
1. All parameters NOT specially mentioned are measured at 230VAC input, rated and 25 of ambient temperature.current ℃
2. Please refer to "DRIVING METHODS OF LED MODULE".
3. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
4. Tolerance : includes set up tolerance, line regulation and load regulation.
5. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.
6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
7. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 70 or less.℃
8. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com
1267.7K hrs min. Telcordia SR-332 (Bellcore) ; 343.9Khrs min. MIL-HDBK-217F (25 )℃
