FTLX1413M3BCL Product Specification
Finisar Corporation – August 2015 Rev D1 Page 5
IV. Optical Characteristics (T
OP
= -5 to 75C, V
CC3
= 3.13 to 3.45 Volts)
Parameter Symbol Min Typ Max Unit Ref.
Transmitter
Output Opt. Pwr: 9/125 SMF P
OUT
-6 -1 dBm 1
Optical Wavelength
1290 1330 nm
Optical Extinction Ratio ER 6 dB 1
Sidemode Supression ratio SSR
min
30 dB
Tx Jitter (SONET/SDH)
20kHz-80MHz
Tx
j1
0.3 UI
Tx Jitter (SONET/SDH)
4MHz – 80MHz
Tx
j2
0.1 UI
Relative Intensity Noise RIN -130 dB/Hz
Receiver
Receiver Sensitivity @ 9.95Gb/s R
SENS1
-14.4 dBm
Receiver Sensitivity @ 10.5Gb/s R
SENS2
-14.4 dBm 2
Receiver Sensitivity @ 11.3Gb/s R
SENS3
-13.4 dBm 2
Stressed Receiver Sensitivity
(OMA) @ 10.5Gb/s
R
SENS4
-10.3 dBm 3
Maximum Input Power P
MAX
+0.5 dBm
Optical Center Wavelength
C
1260 1600 nm
Receiver Reflectance R
rx
-14 dB
LOS De-Assert LOS
D
-18 dBm
LOS Assert LOS
A
-32 dBm
LOS Hysteresis 0.5 dB
Notes:
1. Having ER = 6 dB guarantees that the –6 dBm minimum output power meets IEEE 802.3ae
requirement of OMA=-5.2dBm.
2. Measured with worst ER; BER<10
-12
; 2
31
– 1 PRBS. Complies with –12.6 dBm OMA at ER = 6 dB.
3. Per IEEE 802.3ae. Equivalent to –13.3 dBm average power at Infinite ER, -11.08 dBm at ER = 6 dB.
8.5Gb/s Fibre-Channel:
To operate the FTLX1413D3BCL at 8.5Gb/s Fibre-Channel, the EEPROM-Table 0, Byte
117, Bit 0 must be set as follows; .
EEPROM Byte 117, Bit 0, value “1” for 8GFC:
EEPROM Byte 117, Bit 0 value “0” for 10Gb/s rates:
o (It is also possible to bypass the CDRs with, Byte 111, Bit 0.)
By default, a power cycling the transceiver will return the transceiver to normal 10Gb/s
operation with the CDRs active.
