®
AS7C256A
9/24/04; v.1.2 Alliance Semiconductor P. 6 of 9
AC test conditions
Notes
1During V
CC
power-up, a pull-up resistor to V
CC
on
CE
is required to meet I
SB
specification.
2 For test conditions, see AC Test Conditions, Figures A, B.
3 These parameters are specified with CL = 5pF, as in Figures B. Transition is measured
±500mV from steady-state voltage.
4 This parameter is guaranteed, but not tested.
5
WE
is High for read cycle.
6
CE
and
OE
are Low for read cycle.
7 Address valid prior to or coincident with
CE
transition Low.
8 All read cycle timings are referenced from the last valid address to the first transitioning address.
9 All write cycle timings are referenced from the last valid address to the first transitioning address.
10 C=30pF, except on High Z and Low Z parameters, where C=5pF.
255
Ω
C
10
480
Ω
D
out
GND
+5.0V
168
Ω
D
out
+1.72V
Figure B: Output load
Thevenin equivalent
- Output
oa
: see F
gure B
- Input pulse level: GND to V
CC
See Figure A.
- Input rise and fall times: 2 ns. See Figure A.
- Input and output timing reference levels: 1.5V.
10%
90%
10%
90%
GND
V
CC
Figure A: Input pulse
2 ns