FTLX1413D3BCL Product Specification
Finisar Corporation - August 2015 Rev D1 Page 5
IV. Optical Characteristics (T
OP
= -5 to 75 C, V
CC3
= 3.13 to 3.45 Volts)
Parameter Symbol Min Typ Max Unit Ref.
Transmitter
Optical Modulation Amplitude
(OMA)
P
OMA
-4.8 0 dBm
Maximum Launch Power P
MAX
-6.0 0.5 dBm
Optical Wavelength
1260 1355 nm
Sidemode Supression ratio SSR
min
30 dB
Optical Extinction Ratio ER 3.5 dB
Transmitter and Dispersion Penalty TDP 3.2 dB
Average Launch power of OFF
transmitter
P
OFF
-30 dBm
Tx Jitter Tx
j
Per 802.3ae requirements
Relative Intensity Noise RIN -130 dB/Hz
Receiver
Receiver Sensitivity (OMA)
@ 10.5Gb/s
R
SENS1
-12.6 dBm 1
Stressed Receiver Sensitivity
(OMA) @ 10.5Gb/s
R
SENS2
-10.3 dBm 2
Maximum Input Power P
MAX
+0.5 dBm
Optical Center Wavelength
C
1260 1600 nm
Receiver Reflectance R
rx
-12 dB
LOS De-Assert LOS
D
-18 dBm
LOS Assert LOS
A
-32 dBm
LOS Hysteresis 0.5 dB
Notes:
1. Measured with worst ER; BER<10
-12
; 2
31
– 1 PRBS.
2. Per IEEE 802.3ae. Equivalent to –13.3 dBm average power at Infinite ER.
8.5Gb/s Fibre-Channel:
To operate the FTLX1413D3BCL at 8.5Gb/s Fibre-Channel, the EEPROM-Table 0, Byte
117, Bit 0 must be set as follows; .
EEPROM Byte 117, Bit 0, value “1” for 8GFC:
EEPROM Byte 117, Bit 0 value “0” for 10Gb/s rates:
o (It is also possible to bypass the CDRs with, Byte 111, Bit 0.)
By default, a power cycling the transceiver will return the transceiver to normal 10Gb/s
operation with the CDRs active.
