SpecNo.JELF243A-0122B-01 P.3/8
MURATA MFG.CO., LTD
Reference Only
No. Item Specification Test Method
7.4 Solderability The wetting area of the electrode shall
be at least 90% covered with new solder
coating.
Flux:Ethanol solution of rosin,25(wt)%
(Immersed for 5s to 10s)
Solder : Sn-3.0Ag-0.5Cu
Pre-Heating:150±10°C / 60 to 90s
Solder Temperature:240±5°C
Immersion Time:3±1 s
7.5 Resistance to
Soldering Heat
Appearance: No damage
Inductance Change: within ±10%
Flux: Ethanol solution of rosin,25(wt)%
(Immersed for 5s to 10s)
Solder: Sn-3.0Ag-0.5Cu
Pre-Heating: 150±10°C / 60 to 90seconds
Solder Temperature: 270±5°C
Immersion Time: 10±1 s
Then measured after exposure in the room condition
for 24±2 hours.
8.Environmental Performance (It shall be soldered on the substrate.)
No. Item Specification Test Method
8.1 Heat
Resistance
Appearance:No damage
Inductance Change : within ±10%
Temperature: 85±2°C
Time:1 000± hours
Then measured after exposure in the room condition for
24±2 hours.
8.2 Cold
Resistance
Temperature: -40±2°C
Time: 1000± hours
Then measured after exposure in the room condition for
24±2 hours.
8.3 Humidity Temperature: 70±2°C
Humidity: 90 to 95%(RH)
Time: 1000± hours
Then measured after exposure in the room condition for
24±2 hours.
8.4 Temperature
Cycle
1 cycle:
1 step: -40±2°C / 30±3 min
2 step: Ordinary temp. / 10 to 15 min
3 step: +85±2°C / 30±3 min
4 step: Ordinary temp. / 10 to 15 min
Total of 10 cycles
Then measured after exposure in the room condition for
24±2 hours.
9. Specification of Packaging
9.1 Appearance and Dimensions of plastic tape
(in mm)
Dimension of the Cavity is measured at the bottom side.
4
0
4
0
4
0