Exar Corporation 48720 Kato Road, Fremont CA, 94538 • (510) 668-7000 • FAX (510) 668-7017 • www.exar.com
XRA1402
8-BIT SPI GPIO EXPANDER
SEPTEMBER 2011 REV. 1.0.0
GENERAL DESCRIPTION
The XRA1402 is an 8-bit GPIO expander with an SPI
interface. After power-up, the XRA1402 has internal
100K ohm pull-up resistors on each I/O pin that can
be individually enabled.
In addition, the GPIOs on the XRA1402 can
individually be controlled and configured. As outputs,
the GPIOs can be outputs that are high, low or in
three-state mode. The three-state mode feature is
useful for applications where the power is removed
from the remote devices, but they may still be
connected to the GPIO expander.
As inputs, the internal pull-up resistors can be
enabled or disabled and the input polarity can be
inverted. The interrupt can be programmed for
different behaviors. The interrupts can be
programmed to generate an interrupt on the rising
edge, falling edge or on both edges. The interrupt
can be cleared if the input changes back to its original
state or by reading the current state of the inputs.
The XRA1402 is available in 16-pin QFN and 16-pin
TSSOP packages.
FEATURES
• 1.65V to 3.6V operating voltage
• 8 General Purpose I/Os (GPIOs)
• 5V tolerant inputs
• Maximum stand-by current of 1uA at +1.8V
• SPI bus interface
■ SPI Clock Frequency up to 26MHz
• Individually programmable inputs
■ Internal pull-up resistors
■ Polarity inversion
■ Individual interrupt enable
■ Rising edge and/or Falling edge interrupt
■ Input filter
• Individually programmable outputs
■ Output Level Control
■ Output Three-State Control
• Open-drain active low interrupt output
• Active-low reset input
• 3kV HBM ESD protection per JESD22-A114F
• 200mA latch-up performance per JESD78B
APPLICATIONS
• Personal Digital Assistants (PDA)
• Cellular Phones/Data Devices
• Battery-Operated Devices
• Global Positioning System (GPS)
• Bluetooth
