PP023 Passive Probe
4
EC Declaration of Conformity
The probe is marked with this symbol to show compliance was
demonstrated to the specifications listed in the Official Journal of
the European Communities: Low Voltage Directive 2006/95/EC:
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control and laboratory use – Part 031: Safety requirements
for handheld probe assemblies for electrical measurement and test.
EU RoHS Compliance
The probe and its accessories conform to the 2011/65/EU RoHS2 Directive,
as they have been classified as Industrial Monitoring and Control
Equipment (per Article 3, Paragraph 24) and are exempt from RoHS
compliance until 22 July 2017 (per Article 4, Paragraph 3).
General Safety Information
Observe generally accepted safety procedures in addition to those
listed here to avoid personal injury or damage to equipment.
The
overall safety of any system incorporating this accessory is the
responsibility of the assembler of the system.
Connect only to grounded instruments. Use only with compatible Teledyne
LeCroy oscilloscopes that have their BNC input connected to an earth
ground. Do not connect the probe reference lead to any point which is at a
potential other than earth ground.
Connect and disconnect properly. Connect probe to the oscilloscope before
connecting it to the test circuit. Disconnect the probe input and reference
lead from the test circuit before disconnecting from the oscilloscope. Do
not connect or disconnect probes while they are connected to a voltage
source.
