ADG1419 Data Sheet
Rev. A | Page 14 of 16
TERMINOLOGY
I
DD
The positive supply current.
I
SS
The negative supply current.
V
D
(V
S
)
The analog voltage on Terminal D and Term in a l S.
R
ON
The ohmic resistance between Terminal D and Terminal S.
R
FL AT (ON)
Flatness is defined as the difference between the maximum and
minimum value of on resistance as measured over the specified
analog signal range.
I
S
(Off)
The source leakage current with the switch off.
I
D
(Off)
The drain leakage current with the switch off.
I
D
, I
S
(On)
The channel leakage current with the switch on.
V
INL
The maximum input voltage for Logic 0.
V
INH
The minimum input voltage for Logic 1.
I
INL
(I
INH
)
The input current of the digital input.
C
S
(Off)
The off switch source capacitance, measured with reference to
ground.
C
D
(Off)
The off switch drain capacitance, measured with reference to
ground.
C
D
, C
S
(On)
The on switch capacitance, measured with reference to ground.
C
IN
The digital input capacitance.
t
ON
(EN)
Delay time between the 50% and 90% points of the digital input
and switch on condition. See Figure 27.
t
OFF
(EN)
Delay time between the 50% and 90% points of the digital input
and switch off condition. See Figure 27.
t
TRANSITION
Delay time between the 50% and 90% points of the digital
inputs and the switch on condition when switching from one
address state to another.
T
BBM
Off time measured between the 80% point of both switches
when switching from one address state to another. See Figure 26.
Charge Injection
A measure of the glitch impulse transferred from the digital
input to the analog output during switching. See Figure 28.
Off Isolation
A measure of unwanted signal coupling through an off switch.
See Figure 29.
Crosstalk
A measure of unwanted signal that is coupled through from one
channel to another as a result of parasitic capacitance. See
Figure 30.
Bandwidth
The frequency at which the output is attenuated by 3 dB. See
Figure 31.
On Response
The frequency response of the on switch.
Insertion Loss
The loss due to the on resistance of the switch. See Figure 31.
THD + N
The ratio of the harmonic amplitude plus noise of the signal to
the fundamental. See Figure 32.
AC Power Supply Rejection Ratio (ACPSRR)
ACPSRR measures the ability of a part to avoid coupling noise and
spurious signals that appear on the supply voltage pin to the output
of the switch. The dc voltage on the device is modulated by a
sine wave of 0.62 V p-p. The ratio of the amplitude of signal on
the output to the amplitude of the modulation is the ACPSRR.
See
Figure 21.
