|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
12-07-0005 PT0199-8 07/05/12
5
PT8A2704/04A
Simple Fast Charger Controller
2. Application circuit for smaller discharging current.
If discharging current is smaller, suggest using the following schematic:
PT8A2704/04A Application Circuit for Shaver with Two Batteries
PCB Layout Constraint
1. Cross angle between two Tracks should be larger than 90 degree.
2. Track should be short and wide enough to reduce voltage drop, especially Power supply and Ground as well as some tracks
flowing with large current, such as switch Q1.
3. A ceramic cap C6 about 103 need to add between VT and Ground of PT8A2704 in order to prevent detection circuit from noise.
4. A ceramic cap C7 about 103 and C8 10μF Tan cap need to add between VB to Ground.
How to determine RX1
Assuming Resistance of NTC at 55˚C is RT.
See right figure, below formula can be attained.
VT=RX1*VEE/ (RX1+RT) =1.8V
VEE=2.0V, finally
RX1=9*RT