END START
THERE SHALL BE A
MINIMUM OF 160 mm
(6.3 INCH) OF EMPTY
COMPONENT POCKETS
SEALED WITH COVER
TAPE.
MOUNTED WITH
COMPONENTS
THERE SHALL BE A
MINIMUM OF 160 mm
(6.3 INCH) OF EMPTY
COMPONENT POCKETS
SEALED WITH COVER
TAPE.
MINIMUM OF
230 mm
(9.05 INCH)
MAY CONSIST
OF CARRIER
AND/OR
COVER TAPE.
Figure 12. Tape leader and trailer dimensions
Reow Soldering
For more information on reow soldering, refer to Ap-
plication Note AN-1060, Surface Mounting SMT LED
Indicator Components.
R 0.40
[ SEE TABLE 1 ]
USER FEED
DIRECTION
CARRIER TAPE
COVER TAPE
DIM. B
DIM. A
SEE TABLE 1
DIM. C
SEE TABLE 1
0.20 ± 0.02
0.008 ± 0.001
0.315 ± 0.012
8.00 ± 0.30
1.75
0.069
4.00 ± 0.10
0.157 ± 0.004
2.00 ± 0.05
0.079 ± 0.002
4.00
0.157
1.50
0.059
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.1mm (±0.004in.) unless otherwise specified.
Figure 11. Tape dimensions
Table1.
PART NUMBER DIM.A ± 0.10 (0.004) DIM.B ± 0.10 (0.004) DIM.C ± 0.10 (0.004)
ASMT-CA00 1.75 (0.069) 1.10 (0.043) 0.60 (0.024)
Dimensions In Millimeters (Inches)
Storage Condition
5 to 30°C @ 60%RH max.Baking is required before
mounting, if
1. Humidity Indicator Card is ! 10% when read at 23 r
5qC.
2. Device expose to factory conditions <30qC/60%RH
more than 672 hours.
Recommended baking condition: 60r5qC for 20 hours.
For product information and a complete list of distributors, please go to our web site: www.avagotech.com
Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies in the United States and other countries.
Data subject to change. Copyright © 2005-2010 Avago Technologies. All rights reserved.
AV02-0587EN - May 5, 2010