13©2016 Integrated Device Technology, Inc January 26, 2016
874S02I Data Sheet
Power Considerations
This section provides information on power dissipation and junction temperature for the 874S02I.
Equations and example calculations are also provided.
1. Power Dissipation.
The total power dissipation for the 874S02I is the sum of the core power plus the analog power plus the power dissipated in the load(s).
The following is the power dissipation for V
DD
= 3.3V + 5% = 3.465V, which gives worst case results.
• The maximum current at 85°C is as follows:
I
DD_MAX
= 93mA
I
DDA_MAX
= 19mA
I
DDO_MAX
= 36mA
• Power (core)
MAX
= V
DD_MAX
* (I
DD_MAX
+ I
DDA_MAX
) = 3.465V * (93mA + 19mA) = 388.08mW
• Power (outputs)
MAX
= V
DDO_MAX
* I
DDO_MAX
= 3.465V * 36mA = 124.74mW
Total Power_
MAX
= 388.08mW + 124.74mW = 512.82mW
•
2. Junction Temperature.
Junction temperature, Tj, is the temperature at the junction of the bond wire and bond pad and directly affects the reliability of the device.
The maximum recommended junction temperature for HiPerClockS devices is 125°C.
The equation for Tj is as follows: Tj =
JA
* Pd_total + T
A
Tj = Junction Temperature
JA
= Junction-to-Ambient Thermal Resistance
Pd_total = Total Device Power Dissipation (example calculation is in section 1 above)
T
A
= Ambient Temperature
In order to calculate junction temperature, the appropriate junction-to-ambient thermal resistance
JA
must be used. Assuming no air flow
and a multi-layer board, the appropriate value is 64.7°C/W per Table 7 below.
Therefore, Tj for an ambient temperature of 85°C with all outputs switching is:
85°C + 0.513W * 64.7°C/W = 118.2°C. This is well below the limit of 125°C.
This calculation is only an example. Tj will obviously vary depending on the number of loaded outputs, supply voltage, air flow and the type
of board (single layer or multi-layer).
Table 7. Thermal Resistance
JA
for 20 Lead SOIC, Forced Convection
JA
by Velocity
Linear Feet per Minute 0200500
Multi-Layer PCB, JEDEC Standard Test Boards 64.7°C/W 56.7°C/W 53.5°C/W
