CDSOT23-T24CAN CANbus Protector
Layout Considerations
The fi gure below shows an example of how the Model CDSOT23-T24CAN can be connected on a two-sided PCB design. The device
should be placed as close to the bus connector as possible with short traces to the signal lines. Since the connector pin spacing is
generally much larger than the pin spacing of the transceiver, it is relatively easy to do this. A standard 10 mil, 1 ounce copper trace
is more than adequate to handle the peak current level from the 500 V surge discussed in the previous section. The ground pin of the
device should be connected to the circuit board ground plane using a short trace and a via. If there is a ground plane on the signal
side of the circuit board near where the diode array is placed, it should be connected directly to it.
Specifi cations are subject to change without notice.
The device characteristics and parameters in this data sheet can and do vary in different applications and actual device performance may vary over time.
Users should verify actual device performance in their specifi c applications.
