T42
www.vishay.com
Vishay
Revision: 11-May-16
1
Document Number: 40165
For technical questions, contact: tantalum@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
Solid Tantalum Surface-Mount Capacitors
T
ANTAMOUNT™, Low ESR, Hi-Rel COTS, Built-in-Fuse,
Leadframeless Molded
PERFORMANCE CHARACTERISTICS
Operating Temperature: -55 °C to +125 °C
(above 85 °C, voltage derating is required)
Capacitance: 10 µF to 470 µF
Capacitance Tolerance: ± 10 %, ± 20 %
Voltage Rating: 16 V
DC
to 75 V
DC
FEATURES
• Individually fused multiple anode construction
ensures fail-safe operation and graceful
degradation in the event of failure
• High-reliability design with reliability
screening available
• Surge current testing per MIL-PRF-55365
options available
• Ultra-low ESR
• Fuse characteristics: guaranteed fuse protection at 5 A,
10 ms
• Fuse characteristics are optimized to ensure activation to
protect against catastrophic failures while avoiding false
triggering
• Terminations: wraparound Sn / Pb, standard. 100 % tin
available
• Material categorization: for definitions of compliance
please see www.vishay.com/doc?99912
Note
*
This datasheet provides information about parts that are
RoHS-compliant and / or parts that are non-RoHS-compliant. For
example, parts with lead (Pb) terminations are not RoHS-compliant.
Please see the information / tables in this datasheet for details.
Note
• We reserve the right to supply higher voltage ratings and tighter capacitance tolerance capacitors in the same case size.
Low ESR solid tantalum chip capacitors allow delta ESR of 1.25 times the datasheet limits after mounting.
Available
Available
Available
ORDERING INFORMATION
T42 M2 227 M 025 E S A
TYPE CASE
CODE
CAPACITANCE CAPACITANCE
TOLERANCE
DC VOLTAGE
RATING AT +85 °C
TERMINATION /
PACKAGING
(available options are
series dependent)
RELIABILITY
LEVEL
SURGE
CURRENT
See
Ratings
and
Case
Codes
table
This is expressed in
picofarads. The first
two digits are the
significant figures.
The third is the
number of zeros
to follow.
K = ± 10 %
M = ± 20 %
This is expressed
in volts. To
complete the
three-digit block,
zeros precede the
voltage rating.
A decimal point is
indicated by an “R”
(6R3 = 6.3 V)
E = Sn / Pb solder /
7" (178 mm) reel
L = Sn / Pb solder /
7" (178 mm), 1/2 reel
C = 100 % tin /
7" (178 mm), reel
H = 100 % tin /
7" (178 mm), 1/2 reel
U = 100 % tin /
7" (178 mm), partial
reel (100 pcs/reel)
R = Sn / Pb
7" (178 mm), partial
reel (100 pcs/reel)
S = 40 h
burn-in
Z = non-
established
reliability
A = 10 cycles
at +25 °C
B = 10 cycles
at -55 °C /
+85 °C