TSH346 Using the TSH346 to drive YC, CVBS, YUV, YPbPr and RGB video components
11/18
Figure 25. Shapes of HD video signals coming from DACs including the synchronization tip
(Y signal)
The TSH346 is used to drive high definition video signals up to 30 MHz. It can drive
components such as YPbPr and RGB where the bottom of the signal is close to zero volts.
An internal input DC value is added to the video signal in order to shift the bottom from GND.
The shift is not based on the average of the signal, but is an analog summation of a DC
component to the video signal. Therefore, no input capacitors are required. This provides a
real advantage in terms of cost and board space.
Under these conditions, it is possible to drive the signal in single supply with no saturation of
the driver against the lower rail.
Because half of the signal is lost through output impedance matching, in order to correctly
drive the video line the shifted signal is multiplied by a gain of +2 or +6 dB.
GND
(44t)
27 ns
(2t)
54 ns
(4t)
27 ns
(2t)
(44t)
300 mV
300 mV
s
1100t): 1920/1080i
s
1800t): 1280/720i
•F
ock=74.25 MHz
•t=
Fcloc
=
sync.tip
590 ns
590 ns
Black (30IRE)
AM00827
Image content
Obsolete Product(s) - Obsolete Product(s)
