MP7740 – 15W CLASS D MONO SINGLE ENDED AUDIO AMPLIFIER
MP7740 Rev. 0.9 www.MonolithicPower.com 4
9/22/2009 MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2009 MPS. All Rights Reserved.
PIN FUNCTIONS
Pin # Name Description
1 PIN
Amplifier Positive Input. PIN is the positive side of the differential input to the amplifier. Use a
resistive voltage divider to set the voltage at PIN to V
DD
/2. See Figure 1.
2 NIN
Amplifier Negative Input. NIN is the negative side of the differential input to the amplifier. Drive
the input signal and close the feedback loop at NIN. See Figure 1.
3 AGND Analog Ground. Connect AGND to PGND at a single point.
4 EN Enable Input. Drive EN high to turn on the amplifier, low to turn it off.
5 BS
High-Side MOSFET Bootstrap Input. A capacitor from BS to SW supplies the gate drive
current to the internal high-side MOSFET.
6 VDD
Power Supply Input. VDD is the drain of the high-side MOSFET switch, and supplies the
power to the output stage and the MP7740 internal control circuitry. In addition to the main
bulk capacitor, bypass VDD to PGND with a 1µF X7R capacitor placed close to pins 6 and 8.
7 SW
Switched Power Output. SW is the output of the MP7740. Connect the LC filter between SW
and the output coupling capacitor. See Figure 1.
8 PGND Power Ground. Connect PGND to AGND at a single point.
Exposed
Pad
Connect exposed pad to GND plane for proper thermal performance.