MP3214 – 500mA LED CAMERA FLASH CHARGE PUMP
MP3214 Rev. 1.01 www.MonolithicPower.com 4
6/24/2011 MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2011 MPS. All Rights Reserved.
PIN FUNCTIONS
Pin # Name Description
1
CP
Charge pump bypass for common anode version. Connect a 2.2µF bypass capacitor to GND.
2
C2B
Charge Pump Capacitor #2 Negative Node. Connect the negative side of the #2 charge pump
capacitor to C2B.
3
C1B
Charge Pump Capacitor #1 Negative Node. Connect the negative side of the #1 charge pump
capacitor to C1B.
4
C1A
Charge Pump Capacitor #1 Positive Node. Connect the positive side of the #1 charge pump
capacitor to C1A. Typical applications require C1 to be 1µF.
5,9
GND
Battery Power Ground. Connect the exposed pad to this pin.
6
C2A
Charge Pump Capacitor #2 Positive Node. Connect the positive side of the #2 charge pump
capacitor to C2A. Typical applications require C2 to be 1µF.
7
VIN
Battery Power Input. Connect the 2.5V to 5.5V input source between BATT and GND. Bypass
BATT to GND with a 2.2µF or greater capacitor.
8
EN
Enable input.
10
TOE
Time Out Enable. With TOE=1 the time out is enabled. The device will keep operating for a
period of time after the EN pin goes low.
11
ISET
Current Control Input. Connect a resistor between ISET and GND to set the LED current up
to 500mA.
12,13,16
NC
No connection.
14,15
IOUT
Driver for Flashlight. Connect the flashlight LED between this pin and BATT, with the anode
at BATT.
BLOCK DIAGRAM
Figure 1—Functional Block Diagram