BM28 Series●0.35mm pitch, 0.6mm height, Board to Board or Board to FPC Connectors with Rated Current Up to 5A
8
The characteristics and the specifications contained herein are for reference purpose. Please refer to the latest customer drawings prior to use.
The contents of this catalog are current as of date of 04/2018. Contents are subject to change without notice for the purpose of improvements.
2-6-3,Nakagawa Chuoh,Tsuzuki-Ku,Yokohama-Shi 224-8540,JAPAN
TEL:
+
81-45-620-3526 Fax:
+
81-45-591-3726
http://www.hirose.com
http://www.hirose-connectors.com
®
BM28B0.6-＊DP/2-0.35V
BM28B0.6-＊DS/2-0.35V
Alignment method
When aligning, look for the guide port without applying
excessive force. Caution! If excessive force is applied,
the connector could crack or shaved which could lead
to a defect in contact resistance.
Guiding condition
Mated condition
When guided, the connectors are aligned parallel to
each other, with longitudinal and lateral movements
restricted. Mate them parallel to each other.
Handle with care when mating a connector
Handle with care when un-mating connectors
Un-mate connectors parallel to each other.
Pitch direction
If the connector cannot be un-mated parallel it can be
removed diagonally from the pitch direction, as shown
in the Figure. However, the connector can be broken if
the FPC is not rigid. Please confirm rigidity of the FPC
at the time of trial production.
Corner direction
Do not pull from the corner, If it is pulled from the corner
as shown in the left Figure, the contact and connector
could be damaged.
Please provide a reinforcing plate for the FPC.
If the rigidity of the FPC is not sufficient, the connector may
break as shown in the left Figure. Please check the action of
the FPC to be used repeatedly.
A reinforcing plate of 0.3mm or thicker made of glass epoxy
material is recommended, or 0.2mm or thicker stainless steel.
NG
NG
OK
OK
OK
Aug.1.2018 Copyright 2018 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
Powered by TCPDF (www.tcpdf.org)
