TW8816-LB3-CR

1
DATASHEET
To request the full datasheet, please visit www.intersil.com/products/TW8816b3
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774
| Copyright Intersil Americas LLC 2015. All Rights Reserved
Intersil (and design) is a trademark owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.
LCD Flat Panel Processor with Built-in MCU,
NTSC/PAL/SECAM Decoder, T-CON and Analog RGB
Support
TW8816B3
General Description
The TW8816 is a highly integrated multi-purpose LCD display
solution for both analog and digital panels. To reduce BOM
cost, TW8816 integrates an 8-bit MCU and a CCFL or LED
controller. Through multiple input ports, TW8816 can directly
display video and graphic content from a variety of devices
including TV Tuners, DVD players, back-up cameras, DTV/DMB
receivers and navigation/GPS receivers.
Features
Supports analog inputs including CVBS, S-Video, YPbPr &
RGB signals and digital inputs including 24 bit RGB &
8/16/24 bit YCbCr. Interlaced and progressive ITU 656
inputs are supported.
Supports both digital & analog panels up to WXGA
resolutions
Integrates cost saving features including LED
controller,CCFL controller, programmable panel offset
control and on-chip 8 bit 8051 MCU with SPI interface
Embedded Image Enhancement
- Programmable CTI, hue, brightness, saturation, contrast
& sharpness control
- Black/White Stretch
- Programmable favorite color enhancement- up to three
colors
- Programmable Gamma Correction tables
Analog Video Decoder
NTSC (M, 4.43) and PAL (B, D, G, H, I, M, N, N combination),
PAL (60), SECAM with automatic format detection
Advanced synchronization processing for VCR trick play
signal
Three 10-bit ADCs and analog clamping circuit.
Built-in analog anti-aliasing filter
Fully programmable static gain or automatic gain control for
the Y or CVBS channel
Programmable white peak control for the Y or CVBS channel
Software selectable analog inputs allows any of the
following
- Up to 4 composite video
-UP to 3 S-Video
- Up to 2 analog YPbPr and RGB
4-H adaptive comb filter Y/C separation
PAL delay line for color phase error correction
BOTTOM VIEWDigital PLL for both color and horizontal locking
Programmable hue, brightness, saturation, contrast,
sharpness, Gamma control, and noise suppression
Automatic color control and color killer
Analog RGB / YPbPr Input
Built-in sync processor for SOG support
Built-in Line-locked PLL supporting up to 108MHz
Built-in input measurement function
Digital Interface
Allows connection to 8/16/24-bit RGB/YCbCr
Support both interlaced and progressive ITU 656.
TFT Panel Support
Supports a variety of Digital single pixel TFT panels and
Analog active matrix TFT panels
Supports digital TTL panel up to WXGA(1280 x 768),
100MHz and analog panel up to WQVGA (480 x 234), 20
MHz
Supports 3, 4, 6 or 8 bits per pixel format
Built-in Microcontroller
Supports external SPI Interface and I2C Master interface
with GPIO
Supports 8 MCU GPIO, 1 UART (up to 9600bps)
Support IR or interrupt with GPIO
January 5, 2015
FN7794.3
TW8816B3
2
Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted
in the quality certifications found at www.intersil.com/en/support/qualandreliability.html
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time
without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be
accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third
parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
FN7794.3
January 5, 2015
For additional products, see www.intersil.com/en/products.html
Submit Document Feedback
CCFL and LED Controller
Single channel CCFL controller based on push-pull architecture
•Lamp fault monitoring- Lamp Open, Lamp Over-current, Failure
to Strike and Over-voltage
Programmable Lamp Frequency to move EMI spurs out of
band
Analog or digital brightness control. 300:1 dimming range with
the digital brightness control.
Low power stand-by mode
Fine dimming control step (128 steps)
OSD
Built-in OSD controller with integrated character 202 ROM
fonts, programmable 227 RAM fonts and 512 characters
display RAM.
Multi-window (4) OSD support with color pallet
16 font & window colors available
Support OSD overlay with alpha blending
Image Enhancement
Programmable hue, brightness, saturation, and contrast
controls.
Sharpness control with vertical peaking
•Programmable CTI control
Built-in de-interlacing engine
Independent RGB gain and offset controls
Panorama / Water-glass scaling
•YCbCr hue adjustment
Programmable Gamma correction tables
Programmable favorite color enhancement
Power Management
Supports Panel power sequencing.
Supports DPMS for monitor power management.
1.8 / 3.3 V operation
Timing Controller (TCON)
Support programmable interface signals for control
Column (source) driver / row (gate) driver
Miscellaneous
Supports 2-wire serial bus interface
Spread spectrum PLL
•Low-speed ADC for KEY scan
Programmable panel VCOM offset control
•5V tolerant I/O
•Power-down mode
•DFT
Typical power consumption < 500mW
•Single 27MHz crystal
FIGURE 1. TYPICAL DIAGRAM

TW8816-LB3-CR

Mfr. #:
Manufacturer:
Renesas / Intersil
Description:
Display Drivers & Controllers TW8816-LB3-CR HILY INTEGRTD LCD CNTRLR
Lifecycle:
New from this manufacturer.
Delivery:
DHL FedEx Ups TNT EMS
Payment:
T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet