D1830/A
4 of 7
APPLICATION DIAGRAM — CASCADE DELAY CONFIGURATIONS Figure 4
Note 1: The RST3 output tied to the pushbutton reset would be pulled to V
CC
through the 40kW resistor in
the pushbutton input. If a stronger pull-up is required an additional pull-up resistor could be added.
Note 2: When using the cascade configuration, it is important that the TOL pins of the master and the
slave are configured so that the master’s V
CCTP
is greater than the slave’s V
CCTP
. This will ensure that
when the master’s higher V
CCTP
is crossed, the resets will ripple through to the slave.
TIMING DIAGRAM — POWER-DOWN Figure 5
MASTER
SLAVE
SEE NOTE 2
SEE NOTE 2
SEE NOTE 1