105~150W Constant Current Mode LED Driver
ELG-150-C series
SPECIFICATION
MODEL
RATED CURRENT
RATED
POWER
OUTPUT
CURRENT ADJ. RANGE
SET UP TIME
Note.4
VOLTAGE RANGE Note.3
FREQUENCY RANGE
POWER FACTOR
(Typ.)
EFFICIENCY (Typ.)
AC CURRENT(Typ.)
INPUT
INRUSH CURRENT
(Typ.)
LEAKAGE CURRENT
SAFETY STANDARDS
EMC IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSION
OTHERS
NOTE
PACKING
OVER TEMPERATURE
OVER VOLTAGE
1600ms/115VAC 500ms/230VAC
(Please refer to "STATIC CHARACTERISTIC" section)
47 ~ 63Hz
<0.75mA / 277VAC
Compliance to
EN55015,EN61000-3-2 Class C (@load 60%) ; EN61000-3-3≧
,EAC TP TC 020
; GB17743 GB17625.1,
20 ~ 95% RH non-condensing
-40 ~ +80 , 10 ~ 95% RH℃
±℃ ℃0.03%/ (0 ~ 60 )
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
ENVIRONMENT
EMC EMISSION
SAFETY &
EMC
PROTECTION
Shut down o/p voltage, re-power on to recover
Shut down o/p voltage, re-power on to recover
SHORT CIRCUIT
Hiccup mode, recovers automatically after fault condition is removed
I/P-O/P:3.75KVAC I/P-FG:2.0KVAC O/P-FG:1.5KVAC
I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
CURRENT TOLERANCE
±5.0%
CONSTANT CURRENT REGION
Note.2
TOTAL HARMONIC DISTORTION
OPEN CIRCUIT VOLTAGE
(max.)
Adjustable for A/AB-Type only (via built-in potentiometer)
COLD START 65A(twidth= s measured at 50% Ipeak)/230VAC485 Per NEMA 410μ;
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
3 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC
Tcase=-40 ~ +90 (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)℃
MAX. CASE TEMP.
Tcase=+90℃
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level ( )
surge immunity Line-Earth 6KV, Line-Line 4KV ,EAC TP TC 020
UL8750 (except for BE-type), independent,(type”HL”) CSA C22.2 No. 250.13-12;EN/AS/NZS 61347-1,EN/AS/NZS 61347-2-13
1. All parameters NOT specially mentioned are measured at 230VAC input, rated and 25 of ambient temperature.current ℃
2. Please refer to "DRIVING METHODS OF LED MODULE". For DA-Type, Constant Current region is 60%~100% of maximum voltage
under rated power delivery.
3. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details
4. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.
5. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the
complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
6. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 75 or less.℃
7. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com.
8.The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃
CURRENT RIPPLE 5.0% max. @rated current
100 ~ 305VAC 142 ~ 431VDC continue,320VAC for 24Hrs; 360VAC for 1Hr
ELG-150-C700
107 ~ 214V
700mA
ELG-150-C1050
72 ~ 143V
1050mA
150 ~ 300V
ELG-150-C500
500mA
ELG-150-C1400
54 ~ 107V
1400mA
ELG-150-C1750
43 ~ 86V
1750mA
36 ~ 72V
2100mA
ELG-150-C2100
225V
151V
315V
115V
94V
80V
350 ~ 700mA
525 ~ 1050mA
250 ~ 500mA
700 ~ 1400mA
875 ~ 1750mA
1050 ~ 2100mA
92%
92%
92%
91%
91%
91%
1.7A / 115VAC 0.9A / 230VAC 0.7A/277VAC
230 ~ 265V
155 ~ 180V
320 ~ 360V
128 ~ 150V
96 ~ 106V
82 ~ 92V
2 *63*319 5.5 mm (L*W*H)
0.95Kg; 16pcs / 16.0kg / 0.77CUFT
EN62384; ,EAC TP TC 004,BIS IS15885(for 700A,1050A,700DA only),IP65 or IP67 approvedGB19510.1,GB19510.14
PF 0.97/115VAC, PF 0.95/230VAC, PF 0.92/277VAC@full load≧≧≧
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
THD< 20%(@load 50%/115VC; @load 60%/230VAC; @load 75%/277VAC)≧≧ ≧
(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)
AUXILIARY DC OUTPUT
Nominal 15V(deviation 11.5~15.5V)@0.3A for BE-Type only
No load power consumption <0.5W for Blank / A / Dx / D2-Type
NO LOAD / STANDBY
POWER CONSUMPTION
Standby power consumption <0.5W for B / AB / DA-Type
1098.95K hrs min. Telcordia SR-332 (Bellcore) 308.5Khrs min. MIL-HDBK-217F (25 )℃
105W
105W
105W
105W
105W
105W
200VAC ~ 305VAC
100VAC ~ 180VAC
149.8W
150.15W
150W
149.8W
150.5W
151.2W
(For BE Type only)
(Except for BE Type)
(For All the Types)
134.4W
135W
133W
134.4W
133W
134.4W
CONSTANT CURRENT REGION
Note.2
(For BE Type only)
107 ~ 192V
72 ~ 128V
150 ~ 270V
54 ~ 95V
43 ~ 76V
36 ~ 64V
EFFICIENCY
(Typ.)(for BE Type only)
DALI STANDARDS
Compliance to IEC62386-101,102,207 for DA-Type only
90%
90%
90%
89%
89%
89%
File Name:ELG-150-C-SPEC 2018-05-29
