WSL0603R0250FEA18 Datasheet WSL0603R0250FEA18 | P4-P6

Step-by-Step Installation Instructions

Assemble your Tower System,

including a Tower System controller

module and the TWR-MC-LV3PH

module.

Attach the motor connector from the

BLDCmotortoJ5onthe

TWR-MC-LV3PH. Phase A, phase B,

and phase C are labeled on the

bottom of the board.

Note:ForBLDCmotors,itisimportanttoputthewire

color coded for phase A into the connector terminal

labeled A. Repeat this for phase B and phase C.

Select analog power supply source

bysettingjumpersJ2andJ3

appropriately. If your Tower controller

modulehasterminatedVDDAand

VSSA signals to the primary elevator,

selecttheelevatorsource(position

2-3).Otherwise,selectinternal

source(position1-2).

Connect an encoder or hall sensor

connector from the motor assembly

totheencoder/hallsensorinterface

J8ontheTWR-MC-LV3PH.

Connectacurrent-limitedDCpower

supplytoconnectorJ1.Theinput

voltagerangeis12to24VDC.

Current limit should be set for less

than8amps.Powershouldnotbe

appliedtotheTWR-ELEVorany

other peripheral module.

Whenpowerisapplied,theD7

power-onLEDwillilluminate.The

TWR-MC-LV3PH board powers the

TowerSystemwith5Vand3.3V

on-board power supplies.

Warning

Inputvoltageshigherthan24VmaydamagetheTowerSystemmodule.

The Tower System should only be powered by the TWR-MC-LV3PH module. Supplying power

totheTWR-ELEVorotherperipheralmodulescouldresultindamage.

Quick Start Guide

1 4

TOWER SYSTEM

Jumper Option Setting Description

J2 VDDASourceSelect

1-2 Internal on-board source of analog 3.3V

2-3 Elevatorsourceofanalog3.3V

J3 VSSA Source Select

1-2 Internalon-boardsourceofanalogGND

2-3 ElevatorsourceofanalogGND

J10 AN6 Signal Select

1-2 Phase C current signal

2-3 DC-buscurrentsignal

J11 AN5SignalSelect

1-2 Phase A current signal

2-3 DC-bus/2voltagesignal

J12 AN2SignalSelect

1-2 Phase C current signal

2-3 BackEMFphaseC

J13 AN1SignalSelect

1-2 Phase B current signal

2-3 BackEMFphaseB

J14 AN0SignalSelect

1-2 Phase A current signal

2-3 BackEMFphaseA

TWR-MC-LV3PHJumperOptions

Thefollowingisalistofalljumperoptions.Thedefaultinstalledjumpersettingsare

shown in white text within the black boxes.

Quick Start Guide

P1-P3 P4-P6 P7-P8

WSL0603R0250FEA18

Mfr. #:

Buy WSL0603R0250FEA18

Manufacturer:

Vishay / Dale

Description:

Current Sense Resistors - SMD .2watt .025ohms 1%

Lifecycle:

New from this manufacturer.

Delivery:

DHL FedEx Ups TNT EMS

Payment:

T/T Paypal Visa MoneyGram Western Union

Products related to this Datasheet

WSL0603R0250FEA18