SPECIFICATION RT-1006 ISSUE 2 Page 5
If this document is printed it becomes uncontrolled. Check for the latest revision.
©2005-2009 Tyco Electronics Corporation. All rights reserved
TABLE 1
Requirements
PROPERTY
UNIT REQUIREMENT TEST METHOD
PHYSICAL
Peel Strength
Pounds /inch
width
14 minimum
Section 4.3.1
Flow
Room Temperature
Inch
1 maximum
Section 4.3.2.1
Cure Temperature Inch 1 maximum Section 4.3.2.2
ELECTRICAL
Dielectric Strength
Volts per mil
500 minimum
Section 4.3.3
ASTM D 149
CHEMICAL
Pot Life
Followed by test for:
Hours 1 minimum Section 4.3.4
Peel Strength Pounds /inch
width
10 minimum Section 4.3.1
Solvent Resistance
24 hours at 23 ± 3°C (73 ± 5°F) in:
JP-8 (MIL-DTL-83133)
Skydrol* 500B
Hydraulic Fluid (MIL-H-5606)
Water
Followed by test for:
--- --- Section 4.3.5
Peel Strength Pounds /inch
width
10 minimum Section 4.3.1.2
Note: Unless otherwise specified, latest issue of referenced documents applies.
* Trademark Solutia, Inc.
