Philips Semiconductors Product data
PCK1242925–400 MHz differential PECL clock generator
2
2002 Jun 03 853-2312 28362
INTRODUCTION
The PCK12429 is a general purpose synthesized clock source
targeting applications that require both serial and parallel interfaces.
The differential PECL output can be configured to be the VCO
frequency divided by 1, 2, 4, or 8. With the output configured to
divide the VCO frequency by 2, and with a 16.000 MHz external
quartz crystal used to provide the reference frequency, the output
frequency can be specified in 1 MHz steps. The PLL loop filter is
fully integrated so that no external components are required.
FEATURES
• 25 to 400 MHz differential PECL outputs
• ±25 ps peak-to-peak output jitter
• Fully integrated phase-locked loop
• Minimal frequency over-shoot
• Synthesized architecture
• Serial 3-wire interface
• Parallel interface for power-up
• Quartz crystal interface
• Package offer: SO28, PLCC28, and LQFP32
• Operates from 3.3 V power supply
DESCRIPTION
The internal oscillator uses the external quartz crystal as the basis
of its frequency reference. The output of the reference oscillator is
divided by 16 before being sent to the phase detector.
The VCO output is scaled by a divider that is configured by either
the serial or parallel interfaces. The output of this loop divider is also
applied to the phase detector.
The phase detector and loop filter attempt to force the VCO output
frequency to be M times the reference frequency by adjusting the
VCO control voltage. Note that for some values of M (either too high
or too low) the PLL will not achieve loop lock.
The output of the VCO is also passed through an output divider
before being sent to the PECL output driver. This output divider (N
divider) is configured through either the serial or the parallel
interfaces, and can provide one of four division ratios (1, 2, 4, or 8).
This divider extends performance of the part while providing a 50%
duty cycle.
The output driver is driven differentially from the output divider, and
is capable of driving a pair of transmission lines terminated in 50 Ω
to V
CC
–2.0. The positive reference for the output driver and the
internal logic is separated from the power supply for the
phase-locked loop to minimize noise induced jitter.
The configuration logic has two sections: serial and parallel. The
parallel interface uses the values at the M[8:0] and N[1:0] inputs to
configure the internal counters. Normally, on system reset, the
P_LOAD
input is held LOW until sometime after power becomes
valid. On the LOW-to-HIGH transition of P_LOAD
, the parallel inputs
are captured. The parallel interface has priority over the serial
interface. Internal pullup resistors are provided on the M[8:0] and
N[1:0] inputs to reduce component count in the application of the
chip.
The serial interface centers on a fourteen bit shift register. The shift
register shifts once per rising edge of the S_CLOCK input. The
serial input S_DATA must meet setup and hold timing as specified in
the AC Characteristics section of this document. The configuration
latches will capture the value of the shift register on the
HIGH-to-LOW edge of the S_LOAD input. See the programming
section for more information.
The TEST output reflects various internal node values, and is
controlled by the T[2:0] bits in the serial data stream. See the
programming section for more information.
ORDERING INFORMATION
PACKAGES TEMPERATURE RANGE ORDER CODE DRAWING NUMBER
28-Pin Plastic SO 0 to +70 °C PCK12429D SOT136-1
28-Pin Plastic PLCC 0 to +70 °C PCK12429A SOT261-2
32-pin Plastic LQFP 0 to +70 °C PCK12429BD SOT358-1
