ADG1401/ADG1402
Rev. 0 | Page 14 of 16
TERMINOLOGY
I
DD
The positive supply current.
I
SS
The negative supply current.
V
D
(V
S
)
The analog voltage on Terminal D and Terminal S.
R
ON
The ohmic resistance between Terminal D and Terminal S.
R
FLAT (ON)
Flatness is defined as the difference between the maximum and
minimum value of on resistance as measured over the specified
analog signal range.
I
S
(Off)
The source leakage current with the switch off.
I
D
(Off)
The drain leakage current with the switch off.
I
D
, I
S
(On)
The channel leakage current with the switch on.
V
INL
The maximum input voltage for Logic 0.
V
INH
The minimum input voltage for Logic 1.
I
INL
(I
INH
)
The input current of the digital input.
C
S
(Off)
The off switch source capacitance, measured with reference to
ground.
C
D
(Off)
The off switch drain capacitance, measured with reference to
ground.
C
D
, C
S
(On)
The on switch capacitance, measured with reference to ground.
C
IN
The digital input capacitance.
t
ON
Delay time between the 50% and 90% points of the digital input
and switch on condition. See Figure 23.
t
OFF
Delay time between the 50% and 90% points of the digital input
and switch off condition. See Figure 23.
Charge Injection
A measure of the glitch impulse transferred from the digital
input to the analog output during switching. See Figure 24.
Off Isolation
A measure of unwanted signal coupling through an off switch.
See Figure 25.
Bandwidth
The frequency at which the output is attenuated by 3 dB.
See Figure 26.
On Response
The frequency response of the on switch.
Insertion Loss
The loss due to the on resistance of the switch. See Figure 26.
THD + N
The ratio of the harmonic amplitude plus noise of the signal to
the fundamental. See Figure 27.
AC Power Supply Rejection Ratio (ACPSRR)
ACPSRR measures the ability of a part to avoid coupling noise and
spurious signals that appear on the supply voltage pin to the
output of the switch. The dc voltage on the device is modulated
by a sine wave of 0.62 V p-p. The ratio of the amplitude of the
signal on the output to the amplitude of the modulation is the
ACPSRR. See Figure 19.
