AN5870K
13
SDB00035BEB
■ Technical Information
• Operational explanation
1. SW block
Switches over R, G, B, H, V signal of 2 systems.
SW pin (pin 22) Selected pins
In low-level R in 1 (pin 1), G in 1 (pin 5), B in 1 (pin 9), H in 1 (pin 13), V in 1 (pin 15)
In high-level R in 2 (Pin 3), G in 2 (pin 7), B in 2 (pin 11), H in 2 (pin 14), V in 2 (pin 16)
Input signal Output signal
Sync.-in pin (pin 21) H-in pin (pin 13 · pin 14) H-out pin (pin 19)
●●H-in signal
● Sync.in signal
● H-in signal
DC (state of sync.-in pin)
2. High-level signal detection block
Sync.-in pin (pin 21) is a pin for inputting the sync.-on green signal and it is separated into the
composite sync. signal (composite sync.) inside. H-in 1 and 2 pins (pin 13 or pin 14) are input
pins for the video signal and the separated horizontal signal.
The high-level signal detection block discriminates the presence of H-in signal which is
selected in SW block and provides the output to H-out pin (pin 19) in the following manner.
H signal detection pin (pin 20) voltage becomes under 1 V or over 4 V if H. sync. signal is not
inputted.
The output signal for the H. sync. signal detection pin voltage becomes as follows and it has
hysteresis characteristics. It is possible to adjust the H. sync. signal detection time by means of an
external capacitor.
2V1V0V
1V 2.5V 4V
3V 5V
When rising
from 0 V
(Detection voltage change)
When detecting
H. sync. signal
(Sync.-in signal is selected
when lowed under 1 V)
When decreasing
from 5 V
Sync-in signal selection
(Detection voltage change)
(H-in signal is selected when lowed under 3 V)
H. sync. signal detection
pin voltage
(H-in signal is selected if 2 V is exceeded)
(Detection voltage change)
H-in signal selection
H. sync. signal
detection
pin voltage
(Sync.-in signal is selected
when 4 V is exceeded)
(Detection voltage change)
H. sync. signal
detection
pin voltage
Sync.-in signal selection