Type 12 Mild Steel Two Door Freestanding Enclosure
1418 FS
Series
Continuous Hinge Door with Handle
Application
Designed to house electrical, electronic, hydraulic or pneumatic controls
with provision for panel mounting or rack mounting of equipment.
Provides a degree of protection from falling dirt, dust, oil and water.
Available with front access only or both front and rear access.
A variety of inner panels, rack mounting angles and swing frames are
available to provide flexibility in equipment mounting.
Standards
UL 508 Type 12
CSA Type 12
Complies with
NEMA Type 12
IEC 60529, IP54
Construction
Formed 12 gauge steel (10 gauge on back of single access enclosures).
Smooth, continuously welded seams without knockouts, cutouts or holes.
Stiffeners on the rear of the enclosure provide rigidity. (Single access)
Lifting eyes provide for easy enclosure handling.
Doors are supported with heavy gauge continuous hinges.
Doors are secured with a three point latch and operated with a key locking
automotive type handle.
Latch rods are equipped with rollers for easier door closing.
Oil resistant gaskets are permanently secured.
Provision for light kit mounting.
Mounting channels are welded on the inside of the enclosure for mounting
of optional inner panels or rack equipment rails.
A bonding stud is provided on the door and a grounding stud is provided in
the enclosure for each door.
A literature pocket is provided for the inside of the door (Two pockets are
provided for dual access units).
Finish
Cover and enclosure are finished in recoatable smooth ANSI 61 gray
powder coating on the outside, with white powder coating on the inside.
Optional inner panels, rails, frames and supports are available in white
powder coating.
Accessories
Quality Products. Service Excellence.
