Tyco Electronics
AMP Shanghai Ltd
PAGE
REV LOC
108-60034
O
ASHL-0005- ES REV A
ES
3.5 Test Requirements and Procedures Summary:
Para. Test Items Requirements Procedures
3.5.1 Examination of Product Meets requirements of product drawing
and AMP Spec 114-40054.
Visually, dimensionally and
functionally inspected per applicable
inspection plan
Electrical Requirements
3.5.2
Termination Resistance
R=10 mΩ Max.
AMP Spec 109-6-6
Subject mated contact assembled in
housing to 20 mv maximum open
circuit at 100 ma maximum
See figure 3
3.5.3
Insulation Resistance
1000 M
Ω
Min.
AMP Spec 109-28-4
Test between the adjacent contacts
of mating and unmating samples
3.5.4 Dielectric Withstanding
voltage
750 vac at sea level
1 minute hold with no breakdown
or flashover
AMP Spec 109-29-1
Test between the adjacent contacts
of mating and unmating samples
3.5.5 Capacitance 2 picofarads maximum AMP Spec 109-47
Test between the adjacent contacts
of unmating samples at 1KHZ
Mechanical Requirements
3.5.6 Vibration Random
No electrical discontinuities greater
than 1 microsecond shall occur.
See Note
AMP Spec 109-21-5
Subject mated connectors to 5.35
G’s rms .15 minutes in each of 3
mutually perpendicular planes
See Figure 4
3.5.7 Physical Shock No electrical discontinuity greater than
1 microsecond shall occur.
See Note
AMP Spec 109-26-1
Except 30 G’s
Subject mated connectors to 30 G’s
half-sine shock pulses of 11
millisecond duration; 3 shocks in
each direction applied along the 3
mutually perpendicular planes, total
18 shocks;
See figure 4
3.5.8 Mating Force 35 N maximum
AMP Spec 109-42
Condition A
Measure force necessary to mate
samples at maximum rate of 12.5
mm a minute.
