RPM882-H14
Photo Link Module
3/9
zTerminal description
Terminal
Circuit Function
Pin No
2
1
V
IO
GND
Supply voltage for I/O pins.
(TX-RC, PWDOWN, RXD, TXD)
Ground
Power Supply Terminal
For preventing from infection, connect
a capacitor between V
CC (3pin) and
GND (1pin).
Connect to Ground.
3V
CC
PWDOWN /
LED Mode
RXD
TXD
LEDA
Shield Case
4
5
6
7
8
−
TX-RC
V
IO
V
IO
200k
LED
V
IO
200k
V
IO
V
IO
300k
PWDOWN
RC Transmitting Data Input Terminal
H : LED Emitting
CMOS Logic Level Input
Holding TX-RC='H' status, LED will be
turn off approximately 48µs.
Power-down Control and LED
Intensity switching Terminal
CMOS Logic Level Input
When input is 'H', it will stop the receiving
circuit and Pin-PD current.
H : POWERDOWN (RC transmitting Mode)
L : OPERATION
Receiving Data Output Terminal
CMOS Logic Level Output
When PWDOWN (5pin)= 'H', the RXD
output will be pulled up to V
IO
at
approximately 300kΩ.
Transmitting Data Input Terminal
IrDA TXD input at PWDOWN=L
(Remote control transmitting input at PWDOWN=H
H : LED Emitting
CMOS Logic Level Input
Holding TXD="H" status, LED will be
turn off approximately 48µs.
LED ANODE Terminal
Other power source can be used
difference between LEDV
CC and VCC.
LED current depends on LED load
resistance value at RC mode.