EVERLIGHT ELECTRONICS CO.,LTD.
19-223SURSYGC/S530-A3/E2/TR8
Everlight Electronics Co., Ltd. http://www.everlight.com Rev 2 Page: 10 of 10
Device No:SZDSE-192-018 Prepared date: 29-Apr-2008 Prepared by:Jun Li
4.Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than350℃or 3 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of
the hand solder.
5.Repairing
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD. Tel: 886-2-2267-2000, 2267-9936
Office: No 25, Lane 76, Sec 3, Chung Yang Rd, Fax: 886-2267-6244, 2267-6189, 2267-6306
Tucheng, Taipei 236, Taiwan, R.O.C http://www.everlight.com
