Spec. No.
Subject
Metal Film(Thin Film) Chip Resistors
PRODUCT SPECIFICATION FOR INFORMATION
151-SRA-E102R
Part No.
E R A 3
10
-
3
Panasonic Electronic Devices Co., Ltd.
5. Appearance & Construction
Item Rated value Explanation
Appearance &
Construction
1. The resistive element should be covered with protective coating
that don’t fade easily. The surface of coating should avoid
unevenness, flaw, pinhole and discoloration.
2. The electrode should be printed uniformly, as shown in the
dimensions. The plating should not fade easily, and should avoid
unevenness, flaw, pinhole, projection and discoloration.
3. The electrode should be connected electrically, mechanically to
resistive element.
As far as there shall not designation especially, the following test and measurement
shall be operated under normal temperature (15~35°C), normal humidity(25~75%),
normal atmospheric pressure(
4
108.6 × ~ Pa101.06
5
× ).
6. Performance Specification
Specifications
Item
Chip Resistor
Explanation
DC
Resistance
DC Resistance value shall
be within the specified
tolerance
At 20°C, 65%RH
Temperature
Coefficient
Natural resistance change per
Temperature degree centigrade.
6
10
1)t21(tR
1R2R
×
−
R1 : Resistance value at reference
temperature(t1)
R2 : Resistance value at test
temperature(t2)
t2 – t1 = 100°C t1 = 25°C
Short-time
overload
± (0.5 % + 0.1Ω)
Resistors shall be applied 2.5 times the
rated voltage for 5 seconds.
However, the upper limit of the voltage in the
test shall be 150V.
Dielectric
Withstanding
No evidence of flashover,
mechanical damage,
arcing or insulation break-
down
Insulation
Resistance
Min.
1,000M
Ω
AC 100V between substrate and termination for
1 min.
Resistors shall be facing down. After applying DC
100V to the resistor, insulation resistance shall be
measured.
Resit. range TCR
10Ω
~97.6Ω
± 50x10
-6
/°C
100Ω
~33 kΩ
±25x10
-6
/°C
33.2kΩ
~330kΩ
±100x10
-6
/°C
(10
-6
/℃)
AC
powersupply
or
Insulation
resistance