1SP0635x2xx-25
Preliminary Data Sheet
www.IGBT-Driver.com Page 2
Safety Notice!
The data contained in this data sheet is intended exclusively for technically trained staff. Handling all high-
voltage equipment involves risk to life. Strict compliance with the respective safety regulations is mandatory!
Any handling of electronic devices is subject to the general specifications for protecting electrostatic-sensitive
devices according to international standard IEC 60747-1, Chapter IX or European standard EN 100015 (i.e. the
workplace, tools, etc. must comply with these standards). Otherwise, this product may be damaged.
Important Product Documentation
This data sheet contains only product-specific data. For a detailed description, must-read application notes and
common data that apply to the whole series, please refer to the “Description & Application Manual for
1SP0635 SCALE-2 IGBT Drivers” on www.IGBT-Driver.com/go/1SP0635
.
The gate resistors as well as the auxiliary gate capacitor on this gate driver are not assembled in order to
provide maximum flexibility. For the values required for specific IGBT modules, refer to the paragraph on
“Gate Resistor Assembly”. Use of gate resistors and gate auxiliary capacitors other than those specified may
result in failure.
Mechanical Dimensions
Dimensions: See the relevant “Description and Application Manual”
Mounting principle: Connected to IGBT module with screws
Fiber-Optic Interfaces (1SP0635x2Mx)
Interface Remarks Part type #
Drive signal input 1SP0635V, fiber-optic receiver (Notes 1, 2) HFBR-2522ETZ
Drive signal input 1SP0635S, fiber-optic receiver (Notes 1, 2) HFBR-2412Z
Status output 1SP0635V, fiber-optic transmitter (Notes 1, 3) HFBR-1522ETZ
Status output 1SP0635S, fiber-optic transmitter (Notes 1, 3) HFBR-1412Z
Electrical Connectors
Interface Remarks Part type #
Power supply connector X1 1SP0635x2Mx, on-board connector (Note 4) 214012
Bus connectors X2 and X3 On-board connectors (Note 5) 214013